Free on-site quotes7 days a weekEdmonton · St. Albert · Sherwood Park · Spruce GroveLocally owned & operatedThe Go-To Drywall Contractor for Repair, Restoration & Finishing

Type X board in Central Edmonton for garages, suites and mechanical rooms

Where code requires it in Central Edmonton, fire-rated board is mandatory: garage-to-house separations, suites and party walls take Type X in a rated assembly — for inspection and for safety. In Central Edmonton we install fire-rated drywall to code and finish it clean. Central Edmonton is an Central Edmonton community with a mix of older homes and newer builds, so fire-rated work here is common on garages and suites. We cover Central Edmonton, Boyle Street, Central McDougall, Dovercourt, Downtown, Glenora, Inglewood and Central Edmonton, 7 days a week.

Fire-Rated Drywall Central Edmonton

Watch fire-rated drywall jobs in Central Edmonton on our YouTube channel

Common fire-rated situations in Central Edmonton

Finished garages and new builds

Fire-rated work here is common when garages are finished and on new builds and additions where the separations are part of the spec.

Suite conversions

When an Central Edmonton basement is converted to a legal suite, the fire separation between the suite and the main floor is a code requirement we handle as part of the drywall.

Fire-Rated Drywall in every Central Edmonton community

Where we work in Central Edmonton

We cover fire-rated drywall across Central Edmonton. Pick your community below for the detail that applies to your street.

Joints, screws and the details inspectors actually check

The parts nobody photographs

A rated assembly in Central Edmonton depends on screw spacing, joints landing on framing, and joints being taped and filled. Loose screw spacing, unsupported butt joints and untaped joints are the usual reasons a rated wall does not pass.

Two-layer assemblies

Where the assembly is two layers, the second layer joints are offset from the first so no joint runs straight through the wall. That offset is part of the rating, not a finishing preference.

Fire-rated drywall in a Central Edmonton garage ceiling

The most common one we do

Where Central Edmonton living space sits over a garage, the ceiling normally needs a rated separation. It is also the assembly most often found incomplete on older homes and DIY conversions — board up, joints untaped, pot lights cut straight through.

What we check before quoting

We look at what is above the ceiling, what is already installed, and whether the existing board is actually rated. Sometimes the honest answer is that the existing ceiling only needs its joints completed and its penetrations sealed rather than replacing.

Type X and Type C are not interchangeable

Two different boards

Type X is the common 5/8 inch rated board. Type C carries additional additives that resist shrinkage at high heat and is specified where an assembly — often a ceiling — depends on the board staying in place longer.

Substituting downward fails

Where drawings call for Type C, Type X is not an equivalent, and an inspector who spots it will fail the assembly. We order to the specification on your Central Edmonton drawings and tell you if what is on site does not match it.

Board thickness and why 5/8 is standard here

Not just thicker

Type X is 5/8 inch because the core needs that mass and the glass-fibre reinforcement to hold together as the gypsum calcines under heat.

The common error

Using 1/2 inch board in a rated Central Edmonton assembly because it is what was on site. It looks identical once finished and it is not the tested assembly. Board arriving on site is checked against the specification rather than assumed.

Where Central Edmonton homes usually need rated board

The four common places

Most rated drywall in Central Edmonton houses is one of: the garage ceiling where living space sits above it, the garage-to-house wall, the furnace or mechanical room, and a legal-suite separation between dwelling units.

Renovations trigger it too

Finishing a basement, adding a suite or converting a garage often brings a separation into play that was not there before. If you are not sure whether your Central Edmonton project triggers one, that is a question for the building official at permit stage, and we will tell you when we think you should ask.

Simple, clean, on schedule — Fire-Rated Drywall in Central Edmonton

1

Free quote

We come out to your Central Edmonton property, take a real look at the fire-rated drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every fire-rated drywall quote in Central Edmonton starts with an honest, on-site assessment.

2

Book a day

We pick a day that works for your schedule and show up on time, ready to start the fire-rated drywall in Central Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

3

The work

We keep the dust under control and protect your Central Edmonton home while we finish the fire-rated drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

4

Walk it with you

We don't pack up till you've walked the finished fire-rated drywall with us and you're happy with the result in Central Edmonton. If anything needs a second look, we handle it before we call the job done.

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the fire-rated drywall contractor Central Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your fire-rated drywall project in Central Edmonton.

Read our reviews on Google

Fire-Rated Drywall Central Edmonton: your questions answered

Does the rated wall have to go above the ceiling?
Yes. A separation that stops at a suspended ceiling is not a separation — fire and smoke go over it. The wall runs to the structure above and is sealed at both ends. It is the detail most often missed in conversions.
How do I know which rated assembly my Central Edmonton project needs?
It comes from your drawings or from the building official at permit stage, not from us and not from the board supplier. We build to the assembly you have been given, and if what is specified does not match what is on site we will tell you before boarding.
Do you install fire-rated drywall in Central Edmonton?
Yes — fire-rated drywall in Central Edmonton is part of our regular work, and we are usually booked within the week. We also cover Boyle Street, Central McDougall, Dovercourt, Downtown, Glenora, Inglewood and Central Edmonton.
Can you finish the fire-rated board too?
Yes — your Central Edmonton separation passes code and looks properly finished, ready for paint.
Can pot lights go in a rated ceiling?
Only with fixtures and firestopping suited to that assembly. A standard fixture cut into a rated Central Edmonton ceiling breaks the separation. We coordinate the locations with your electrician so the penetrations are handled before we tape.
Do you handle the firestopping as well as the board?
We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.

Need Edmonton’s go-to drywall contractor for repair, restoration and finishing? One trusted team for boarding, taping, finishing, repairs & renovations — start to finish.

Your Drywall Contractor in Edmonton →
Get Your Free Drywall Quote
Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.
No obligation. We never share your information.
📞  Call (403) 829-8702 Free Quote

Fire-Rated Drywall in every Central Edmonton community

See our latest drywall projects & updates on FacebookFollow Emplastrum Drywall — Edmonton, St. Albert, Sherwood Park, Spruce Grove & Stony Plain Follow on Facebook