Do you frame basement developments in Riverdale?

Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Boyle Street, Central McDougall, Dovercourt and Central.

Should basement framing touch the concrete?

No. That puts wood and insulation against a cold and sometimes damp surface with no way to dry. The wall is held off, or a rigid layer goes on the concrete first. It costs an inch of floor and saves a musty basement.

Can the same crew do the drywall after framing in Riverdale?

Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.

Can you take out this wall?

Only once we know it is not load-bearing, and that needs drawings or an engineer rather than an assumption. If it is bearing, the job becomes beams and posts — far better priced before demolition than discovered during it.

What is crowning a stud?

Sighting each stud and setting them all with the bow facing the same way so the wall plane is consistent. Studs set randomly give a wall that waves, and in an Riverdale room with a window running along it that shows through the paint.

Do you build bulkheads around ducting in Riverdale?

Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.

Framing Riverdale Edmonton | Stud Walls

Framing in Boyle Street, Central McDougall, Dovercourt, square and ready for drywall

Boyle Street, Central McDougall, Dovercourt coverage — we come to you
Interior partition walls framed square and plumb
Bulkheads and soffits for ductwork and lighting
Wood-frame basement development layouts in Riverdale
Frame-to-finish: one crew frames, boards, tapes and finishes
Door rough openings framed to spec
Stud spacing matched to the drywall going over it

Layout for the sheet, not just for the room

Where the joints will land

Framing at the right spacing and adding backing where a sheet edge will fall means the board has something to fasten to at every joint.

Butt joints

An unsupported butt joint in an Riverdale wall is the hardest thing in drywall to hide. Thinking about sheet layout at framing stage removes them, and it costs nothing but attention.

Riverdale drywall in context

About Riverdale

Just east of City Hall and bounded to the south and east by the river, this large flat area is an important part of Edmonton's history.

What we see in Riverdale

In Riverdale the drywall work is infill new-build settling beside original-stock plaster/popcorn work. We confirm what your home actually needs on site, in writing, before anything starts.

Our Riverdale framing process in Edmonton, step by step

Layout before lumber

We chalk the plate lines from the plan or your walk-through direction and confirm every wall location in your Riverdale space before anything is cut.

Square, plumb, spaced right

We frame the walls square and plumb with stud spacing matched to the board going over them — the frame stage is where a wavy wall gets built or avoided. See our basement drywall work in Riverdale for the stage that follows.

Backing for everything that gets fixed later

Decide before it closes

Grab bars, TV mounts, floating shelves, cabinets, handrails and towel rails all need something solid behind the board.

The cheap moment

Adding backing while the Riverdale wall is open takes minutes. Finding it missing after the wall is finished means opening it or relying on hollow-wall anchors that eventually pull out. We ask what is going on the walls before we close them.

Bulkheads, and why they are never straight by accident

Boxing what has to stay

Riverdale basements are full of ducts, beams and plumbing that cannot move. Bulkheads box them, and each one adds corners.

Getting them right

A bulkhead framed slightly out of square is obvious once it is boarded, because the eye follows its long lines. They take longer than their size suggests and they are worth the extra care.

Crowning studs and checking for bow

Every stud has a curve

Lumber is rarely straight. Crowning means sighting each stud and setting them all with the bow facing the same way so the wall plane is consistent.

What happens without it

Studs set randomly give a wall that waves in and out, and in an Riverdale room with a window running along it, that shows through the finished paint no matter how good the taping.

Framing decides how good the drywall can be in Edmonton

The finish inherits the frame

A wall that is out of plumb or has a bowed stud cannot be made flat with compound. Every problem left in an Riverdale frame becomes a finishing problem and then a visible one.

Why one crew helps

When the people framing know they will also be boarding and finishing, the incentive to crown studs properly and set a straight line is immediate rather than someone else's issue.

How it works

Simple, clean, on schedule — Framing in Riverdale Edmonton

Free quote

We come out to your Riverdale Edmonton property, take a real look at the framing, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every framing quote in Riverdale Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the framing in Riverdale Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Riverdale Edmonton home while we finish the framing to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished framing with us and you're happy with the result in Riverdale Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the framing contractor Riverdale Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your framing project in Riverdale Edmonton.

Read our reviews on Google

FAQ — Framing Riverdale Edmonton

Framing Riverdale Edmonton: your questions answered

Do you frame basement developments in Riverdale?: Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Boyle Street, Central McDougall, Dovercourt and Central.
Should basement framing touch the concrete in Edmonton?: No. That puts wood and insulation against a cold and sometimes damp surface with no way to dry. The wall is held off, or a rigid layer goes on the concrete first. It costs an inch of floor and saves a musty basement.
Can the same crew do the drywall after framing in Riverdale in Edmonton?: Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.
Can you take out this wall?: Only once we know it is not load-bearing, and that needs drawings or an engineer rather than an assumption. If it is bearing, the job becomes beams and posts — far better priced before demolition than discovered during it.
What is crowning a stud?: Sighting each stud and setting them all with the bow facing the same way so the wall plane is consistent. Studs set randomly give a wall that waves, and in an Riverdale room with a window running along it that shows through the paint.
Do you build bulkheads around ducting in Riverdale?: Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Framing

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Framing Riverdale Edmonton

Framing in Boyle Street, Central McDougall, Dovercourt, square and ready for drywall