Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.

Can you just add over what is already up there?

Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Cellulose or fibreglass?

Both work. Cellulose is denser, packs into odd shapes and resists air movement through it better; fibreglass is lighter, which matters on a ceiling of uncertain strength. Where there is existing material, matching it is usually simpler than layering the other over it.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

Loose Fill Insulation Wild Rose Edmonton | Blown-In

Loose-fill insulation in Wild Rose — settled depth is what you are buying

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Wild Rose attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

Depth read back at the corners, not just where the hatch is
Settled depth specified and marked before the hose starts
Baffles at the eaves so soffit venting stays clear
Existing material assessed — topped up, or removed if it is wet or contaminated
Ceiling penetrations air-sealed first, not buried
Even coverage carried right out over the top plates

Bag count is the honest check

Coverage is arithmetic

Every bag states the area it covers at a given depth. Bags used, divided by area, tells you exactly what was installed.

Why we keep them

Depth can be probed in a few spots and averaged; the bag count cannot be argued with. On an Wild Rose attic it is the simplest proof that what was quoted is what went in.

Wild Rose drywall in context

About Wild Rose

Wild Rose is named for Alberta's official flower, Rosa acicularis (wild rose), which has been this province's official flower since the 1930s.

What we see in Wild Rose

In Wild Rose the drywall work is first-year settling, basement dev for first owners, Level 5 over builder-grade. We confirm what your home actually needs on site, in writing, before anything starts.

The hatch, again, because it undoes the rest

The one gap left

You can blow a perfect even depth across an Wild Rose ceiling and still lose heat through an uninsulated hatch that loose material spills through every time it opens.

What it needs

An insulated, weatherstripped cover and a dam around the opening high enough to hold the new depth back.

Bath fans and the ducts above the ceiling

A very common find

Fans discharging into the attic instead of outside, or a duct that has come off its boot and is blowing into the insulation.

Why it belongs in this job

It is the fastest way to soak an Wild Rose attic from inside. We look for it while the space is open and flag it before covering anything, rather than blowing over the top.

Storage areas and the platform question

The trade-off is real

Anything laid on the joists compresses loose-fill and cuts a thin channel through the middle of an Wild Rose ceiling.

Doing it properly

If storage is genuinely needed, a raised platform over a limited area lets full depth continue underneath. Otherwise the honest answer is that a fully insulated attic is not also a storage room.

Access, hoses and how much of the house we cross

Practical reality

The machine sits outside and a hose runs to the Wild Rose attic hatch, which usually means through a hallway or a closet.

Keeping it clean

Protected route, sealed hatch surround, the space vacuumed after. It is a dusty trade and the difference between a good crew and a bad one is mostly what the house looks like at the end.

How it works

Simple, clean, on schedule — Drywall in Edmonton

Free quote

We come out to your Edmonton property, take a real look at the drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every drywall quote in Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the drywall in Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Edmonton home while we finish the drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished drywall with us and you're happy with the result in Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the drywall contractor Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your drywall project in Edmonton.

Read our reviews on Google

FAQ — Loose Fill Insulation Wild Rose Edmonton

Loose Fill Insulation Wild Rose Edmonton: your questions answered

Can you blow insulation into my walls without opening them?: Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.
Can you just add over what is already up there?: Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.
Does the attic hatch need doing too?: Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.
What about my pot lights?: Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.
Cellulose or fibreglass?: Both work. Cellulose is denser, packs into odd shapes and resists air movement through it better; fibreglass is lighter, which matters on a ceiling of uncertain strength. Where there is existing material, matching it is usually simpler than layering the other over it.
Does loose-fill settle?: Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

📐 Plan Your Project

Estimate Your Insulation

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Loose Fill Insulation Wild Rose Edmonton

Loose-fill insulation in Wild Rose — settled depth is what you are buying