Loose Fill Insulation Westview Village

Blown-in insulation for Westview Village attics and closed cavities

Blown-in material fills the awkward parts of an Westview Village building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Baffles at the eaves so soffit venting stays clear
• Settled depth specified and marked before the hose starts
• Depth read back at the corners, not just where the hatch is
• Ceiling penetrations air-sealed first, not buried
• Even coverage carried right out over the top plates
• Existing material assessed — topped up, or removed if it is wet or contaminated

Loose Fill Insulation Westview Village

Bath fans and the ducts above the ceiling

Westview Village drywall in context

Topping up what is already there

Settled depth versus installed depth

Loose-fill or batts, decided on the space

Storage areas and the platform question

Bag count is the honest check

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Westview Village: your questions answered

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

Cellulose or fibreglass?

Both work. Cellulose is denser, packs into odd shapes and resists air movement through it better; fibreglass is lighter, which matters on a ceiling of uncertain strength. Where there is existing material, matching it is usually simpler than layering the other over it.

Can you just add over what is already up there?

Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.