Loose Fill Insulation Westbrook Estates

Blown-in insulation for Westbrook Estates attics and closed cavities

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Westbrook Estates attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

• Settled depth specified and marked before the hose starts
• Depth read back at the corners, not just where the hatch is
• Baffles at the eaves so soffit venting stays clear
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Even coverage carried right out over the top plates
• Ceiling penetrations air-sealed first, not buried

Loose Fill Insulation Westbrook Estates

What it does for sound

Westbrook Estates drywall in context

Blowing into a wall that is already closed

The hatch, again, because it undoes the rest

Settled depth versus installed depth

Loose-fill or batts, decided on the space

Topping up what is already there

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Westbrook Estates: your questions answered

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

How is old insulation removed?

With a vacuum and hose into sealed bags, not shovels, because disturbing decades of settled material raises a lot of dust. It also gives a clean deck to air-seal and a look at the structure before it is covered again.

Can you just add over what is already up there?

Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.

Do you seal before blowing?

Yes, and it is the step most often skipped. Loose material laid over an open ceiling penetration hides the leak rather than stopping it, and the warm moist air coming through is what wets the insulation from inside.