Loose Fill Insulation Virginia Park

Blown-in insulation for Virginia Park attics and closed cavities

Blown-in material fills the awkward parts of an Virginia Park building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Ceiling penetrations air-sealed first, not buried
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Baffles at the eaves so soffit venting stays clear
• Depth read back at the corners, not just where the hatch is
• Even coverage carried right out over the top plates

Loose Fill Insulation Virginia Park

Removing old loose-fill

Virginia Park drywall in context

What we hand over at the end

The hatch, again, because it undoes the rest

Storage areas and the platform question

Access, hoses and how much of the house we cross

Blowing into a wall that is already closed

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Virginia Park: your questions answered

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Can you just add over what is already up there?

Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.