Loose Fill Insulation Twin Brooks Edmonton

Blown-in insulation for Twin Brooks attics and closed cavities

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Twin Brooks attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

• Even coverage carried right out over the top plates
• Ceiling penetrations air-sealed first, not buried
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Depth read back at the corners, not just where the hatch is
• Settled depth specified and marked before the hose starts
• Baffles at the eaves so soffit venting stays clear

Loose Fill Insulation Twin Brooks Edmonton

Settled depth versus installed depth

Twin Brooks drywall in context

Knob-and-tube and older wiring

Access, hoses and how much of the house we cross

Removing old loose-fill

The hatch, again, because it undoes the rest

Working in a cathedral or a low attic

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Twin Brooks Edmonton: your questions answered

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

Can I still store things in the attic?

Only over a raised platform. Anything laid straight on the joists compresses the material and cuts a thin channel through the middle of the ceiling. Otherwise a fully insulated attic is not also a storage room.

Will it make the house quieter?

It noticeably reduces airborne noise from outside — traffic, aircraft, neighbours. It does very little for footsteps from a floor above, which travel through structure, and we would rather say which half it fixes.

Is it too heavy for my ceiling?

Rarely, but worth thinking about on an older lath ceiling or a long unsupported span. Where the ceiling is old or already sagging we would rather use the lighter material at a sensible depth, and sometimes recommend fixing the ceiling first.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.