Loose Fill Insulation Strathcona

Loose-fill insulation in Strathcona — settled depth is what you are buying

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Strathcona attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

• Even coverage carried right out over the top plates
• Depth read back at the corners, not just where the hatch is
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Settled depth specified and marked before the hose starts
• Baffles at the eaves so soffit venting stays clear
• Ceiling penetrations air-sealed first, not buried

Loose Fill Insulation Strathcona

Topping up what is already there

Strathcona drywall in context

Blowing into a wall that is already closed

Bag count is the honest check

Storage areas and the platform question

Bath fans and the ducts above the ceiling

Loose-fill or batts, decided on the space

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Strathcona: your questions answered

Will it make the house quieter?

It noticeably reduces airborne noise from outside — traffic, aircraft, neighbours. It does very little for footsteps from a floor above, which travel through structure, and we would rather say which half it fixes.

My bathroom fan vents into the attic. Does that matter?

A great deal — it is the fastest way to soak an attic from inside. We look for it while the space is open and flag it before covering anything rather than blowing over the top of it.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

What do I get when the job is done?

The bag count, the target settled depth, and photographs of the finished space including the corners and the eaves — so you can confirm years later what was actually installed instead of probing a hole and guessing.

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.