Loose Fill Insulation Steinhauer

Loose-fill insulation in Steinhauer — settled depth is what you are buying

Blown-in material fills the awkward parts of an Steinhauer building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Even coverage carried right out over the top plates
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Depth read back at the corners, not just where the hatch is
• Baffles at the eaves so soffit venting stays clear
• Ceiling penetrations air-sealed first, not buried
• Settled depth specified and marked before the hose starts

Loose Fill Insulation Steinhauer

Access, hoses and how much of the house we cross

Steinhauer drywall in context

What it does for sound

The material must not block the eaves

Bag count is the honest check

Weight on the ceiling below

Bath fans and the ducts above the ceiling

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Steinhauer: your questions answered

What do I get when the job is done?

The bag count, the target settled depth, and photographs of the finished space including the corners and the eaves — so you can confirm years later what was actually installed instead of probing a hole and guessing.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

My bathroom fan vents into the attic. Does that matter?

A great deal — it is the fastest way to soak an attic from inside. We look for it while the space is open and flag it before covering anything rather than blowing over the top of it.