Loose Fill Insulation St. Albert

Blown-in insulation for St. Albert attics and closed cavities

Blown-in material fills the awkward parts of an St. Albert building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Depth read back at the corners, not just where the hatch is
• Ceiling penetrations air-sealed first, not buried
• Settled depth specified and marked before the hose starts
• Baffles at the eaves so soffit venting stays clear
• Even coverage carried right out over the top plates
• Existing material assessed — topped up, or removed if it is wet or contaminated

Loose Fill Insulation St. Albert

Topping up what is already there

St. Albert drywall in context

Cellulose or fibreglass, and when it matters

Storage areas and the platform question

Loose-fill or batts, decided on the space

Settled depth versus installed depth

The material must not block the eaves

Simple, clean, on schedule — Drywall in St Albert

Loose Fill Insulation St. Albert: your questions answered

Can I still store things in the attic?

Only over a raised platform. Anything laid straight on the joists compresses the material and cuts a thin channel through the middle of the ceiling. Otherwise a fully insulated attic is not also a storage room.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.

Cellulose or fibreglass?

Both work. Cellulose is denser, packs into odd shapes and resists air movement through it better; fibreglass is lighter, which matters on a ceiling of uncertain strength. Where there is existing material, matching it is usually simpler than layering the other over it.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

What do I get when the job is done?

The bag count, the target settled depth, and photographs of the finished space including the corners and the eaves — so you can confirm years later what was actually installed instead of probing a hole and guessing.