Loose Fill Insulation Sherwood

Loose-fill insulation in Sherwood, measured rather than estimated

Blown-in material fills the awkward parts of an Sherwood building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Baffles at the eaves so soffit venting stays clear
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Settled depth specified and marked before the hose starts
• Depth read back at the corners, not just where the hatch is
• Ceiling penetrations air-sealed first, not buried
• Even coverage carried right out over the top plates

Loose Fill Insulation Sherwood

Cellulose or fibreglass, and when it matters

Sherwood drywall in context

Blowing into a wall that is already closed

Topping up what is already there

Settled depth versus installed depth

Access, hoses and how much of the house we cross

Weight on the ceiling below

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Sherwood: your questions answered

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

What do I get when the job is done?

The bag count, the target settled depth, and photographs of the finished space including the corners and the eaves — so you can confirm years later what was actually installed instead of probing a hole and guessing.

How is old insulation removed?

With a vacuum and hose into sealed bags, not shovels, because disturbing decades of settled material raises a lot of dust. It also gives a clean deck to air-seal and a look at the structure before it is covered again.

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

Can you just add over what is already up there?

Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.