Loose Fill Insulation Rutherford Edmonton

Blown-in insulation for Rutherford attics and closed cavities

Blown-in material fills the awkward parts of an Rutherford building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Ceiling penetrations air-sealed first, not buried
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Baffles at the eaves so soffit venting stays clear
• Depth read back at the corners, not just where the hatch is
• Even coverage carried right out over the top plates

Loose Fill Insulation Rutherford Edmonton

Bath fans and the ducts above the ceiling

Rutherford drywall in context

Weight on the ceiling below

Working in a cathedral or a low attic

Cellulose or fibreglass, and when it matters

Knob-and-tube and older wiring

Topping up what is already there

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Rutherford Edmonton: your questions answered

Can I still store things in the attic?

Only over a raised platform. Anything laid straight on the joists compresses the material and cuts a thin channel through the middle of the ceiling. Otherwise a fully insulated attic is not also a storage room.

What do I get when the job is done?

The bag count, the target settled depth, and photographs of the finished space including the corners and the eaves — so you can confirm years later what was actually installed instead of probing a hole and guessing.

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.