Loose Fill Insulation Rural North East South Sturgeon Edmonton

Loose-fill insulation in Rural North East South Sturgeon, measured rather than estimated

Blown-in material fills the awkward parts of an Rural North East South Sturgeon building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Depth read back at the corners, not just where the hatch is
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Even coverage carried right out over the top plates
• Baffles at the eaves so soffit venting stays clear
• Ceiling penetrations air-sealed first, not buried

Loose Fill Insulation Rural North East South Sturgeon Edmonton

Working in a cathedral or a low attic

Rural North East South Sturgeon drywall in context

Bath fans and the ducts above the ceiling

The hatch, again, because it undoes the rest

Weight on the ceiling below

Storage areas and the platform question

Blowing into a wall that is already closed

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Rural North East South Sturgeon Edmonton: your questions answered

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Cellulose or fibreglass?

Both work. Cellulose is denser, packs into odd shapes and resists air movement through it better; fibreglass is lighter, which matters on a ceiling of uncertain strength. Where there is existing material, matching it is usually simpler than layering the other over it.

Is it too heavy for my ceiling?

Rarely, but worth thinking about on an older lath ceiling or a long unsupported span. Where the ceiling is old or already sagging we would rather use the lighter material at a sensible depth, and sometimes recommend fixing the ceiling first.

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.