Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Can I still store things in the attic?

Only over a raised platform. Anything laid straight on the joists compresses the material and cuts a thin channel through the middle of the ceiling. Otherwise a fully insulated attic is not also a storage room.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Loose Fill Insulation Parkdale | Loose Fill Insulation

Blown-in insulation for Parkdale attics and closed cavities

Blown-in material fills the awkward parts of an Parkdale building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

Depth read back at the corners, not just where the hatch is
Ceiling penetrations air-sealed first, not buried
Existing material assessed — topped up, or removed if it is wet or contaminated
Settled depth specified and marked before the hose starts
Baffles at the eaves so soffit venting stays clear
Even coverage carried right out over the top plates

Cellulose or fibreglass, and when it matters

Two common materials

Cellulose is recycled paper treated for fire and pests; loose-fill fibreglass is the same glass wool as a batt, chopped. Both work.

How we choose for an Parkdale attic

Cellulose is denser, packs into odd shapes well and resists air movement through it better. Fibreglass is lighter, which matters on a ceiling of uncertain strength. Where the existing material is one of them, matching it is usually simpler than layering the other over top.

Parkdale drywall in context

About Parkdale

Parkdale is a low-density residential neighbourhood close to the inner city featuring primarily single-family homes as well as some commercial and industrial areas.

What we see in Parkdale

In Parkdale the drywall work is plaster and lath repair, popcorn and stipple ceiling removal, careful patching into original surfaces. We confirm what your home actually needs on site, in writing, before anything starts.

Blowing into a wall that is already closed

Dense-pack

Loose-fill can be blown into closed Parkdale wall cavities through small holes, packed to a density that stops it slumping and leaving a cold band at the top.

Where it fits

It suits an older home you do not want to open up. It needs the holes made, filled and finished afterwards, which is drywall work — so quote the patching with it rather than discovering it later.

Loose-fill or batts, decided on the space

Not a loyalty question

Batts suit open framing at regular spacing. Loose-fill suits irregular, obstructed or already-closed spaces.

How we quote it

We look at the Parkdale space and recommend the one that fits it, including saying when a mix is right — batts in the open framed walls, blown-in above the ceiling. Nobody should be sold the material the truck happens to carry.

Working in a cathedral or a low attic

Not every space suits it

A vented sloped ceiling needs its air channel kept clear, and a shallow attic may not have room for the hose or the depth.

Being straight about it

Where an Parkdale roof space cannot take a proper depth without blocking ventilation, we say what the space can actually achieve instead of quoting a number the geometry will not allow.

What it does for sound

A side benefit

A deep layer of loose-fill over an Parkdale ceiling noticeably reduces airborne noise from outside — traffic, aircraft, neighbours.

Being clear about limits

It does very little for footsteps from a floor above, which travel through structure. If quieting the house is the real goal we would rather say which half this fixes.

Pot lights buried in loose material

A heat question

Older recessed fixtures are not all rated to be covered, and loose-fill packs right against them.

What we check

Whether the Parkdale fixtures are rated for insulation contact. Where they are not, they get a proper clearance detail rather than being buried and hoped about — and that detail is also a sealed one, so it does not become a new air leak.

How it works

Simple, clean, on schedule — Drywall in Edmonton

Free quote

We come out to your Edmonton property, take a real look at the drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every drywall quote in Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the drywall in Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Edmonton home while we finish the drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished drywall with us and you're happy with the result in Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the drywall contractor Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your drywall project in Edmonton.

Read our reviews on Google

FAQ — Loose Fill Insulation Parkdale

Loose Fill Insulation Parkdale: your questions answered

Does the attic hatch need doing too?: Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.
What about my pot lights?: Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.
Can I still store things in the attic?: Only over a raised platform. Anything laid straight on the joists compresses the material and cuts a thin channel through the middle of the ceiling. Otherwise a fully insulated attic is not also a storage room.
Does loose-fill settle?: Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.
How messy is it?: Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.
What if you find old wiring?: If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Insulation

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Loose Fill Insulation Parkdale

Blown-in insulation for Parkdale attics and closed cavities