Loose Fill Insulation Minchau Edmonton

Loose-fill insulation in Minchau — settled depth is what you are buying

Blown-in material fills the awkward parts of an Minchau building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Depth read back at the corners, not just where the hatch is
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Even coverage carried right out over the top plates
• Baffles at the eaves so soffit venting stays clear
• Ceiling penetrations air-sealed first, not buried

Loose Fill Insulation Minchau Edmonton

Bath fans and the ducts above the ceiling

Minchau drywall in context

Topping up what is already there

Weight on the ceiling below

What we hand over at the end

Settled depth versus installed depth

The material must not block the eaves

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Minchau Edmonton: your questions answered

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

Will it make the house quieter?

It noticeably reduces airborne noise from outside — traffic, aircraft, neighbours. It does very little for footsteps from a floor above, which travel through structure, and we would rather say which half it fixes.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

Is it too heavy for my ceiling?

Rarely, but worth thinking about on an older lath ceiling or a long unsupported span. Where the ceiling is old or already sagging we would rather use the lighter material at a sensible depth, and sometimes recommend fixing the ceiling first.

Can you just add over what is already up there?

Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.