Loose Fill Insulation Menisa

Loose-fill insulation in Menisa, measured rather than estimated

Blown-in material fills the awkward parts of an Menisa building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Ceiling penetrations air-sealed first, not buried
• Baffles at the eaves so soffit venting stays clear
• Even coverage carried right out over the top plates
• Depth read back at the corners, not just where the hatch is
• Existing material assessed — topped up, or removed if it is wet or contaminated

Loose Fill Insulation Menisa

Bath fans and the ducts above the ceiling

Menisa drywall in context

Working in a cathedral or a low attic

Storage areas and the platform question

Topping up what is already there

Loose-fill or batts, decided on the space

What we hand over at the end

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Menisa: your questions answered

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.

Is it too heavy for my ceiling?

Rarely, but worth thinking about on an older lath ceiling or a long unsupported span. Where the ceiling is old or already sagging we would rather use the lighter material at a sensible depth, and sometimes recommend fixing the ceiling first.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

How is old insulation removed?

With a vacuum and hose into sealed bags, not shovels, because disturbing decades of settled material raises a lot of dust. It also gives a clean deck to air-seal and a look at the structure before it is covered again.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.