Loose Fill Insulation Mcconachie Area Edmonton

Blown-in insulation for Mcconachie Area attics and closed cavities

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Mcconachie Area attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

• Existing material assessed — topped up, or removed if it is wet or contaminated
• Ceiling penetrations air-sealed first, not buried
• Baffles at the eaves so soffit venting stays clear
• Settled depth specified and marked before the hose starts
• Depth read back at the corners, not just where the hatch is
• Even coverage carried right out over the top plates

Loose Fill Insulation Mcconachie Area Edmonton

Cellulose or fibreglass, and when it matters

Mcconachie Area drywall in context

Weight on the ceiling below

Filling around bracing and trusses

Working in a cathedral or a low attic

Removing old loose-fill

Loose-fill or batts, decided on the space

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Mcconachie Area Edmonton: your questions answered

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

Do you seal before blowing?

Yes, and it is the step most often skipped. Loose material laid over an open ceiling penetration hides the leak rather than stopping it, and the warm moist air coming through is what wets the insulation from inside.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

What do I get when the job is done?

The bag count, the target settled depth, and photographs of the finished space including the corners and the eaves — so you can confirm years later what was actually installed instead of probing a hole and guessing.