Loose Fill Insulation Lynnwood Edmonton

Loose-fill insulation in Lynnwood, measured rather than estimated

Blown-in material fills the awkward parts of an Lynnwood building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Baffles at the eaves so soffit venting stays clear
• Even coverage carried right out over the top plates
• Ceiling penetrations air-sealed first, not buried
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Depth read back at the corners, not just where the hatch is

Loose Fill Insulation Lynnwood Edmonton

The hatch, again, because it undoes the rest

Lynnwood drywall in context

Moisture is what ruins it

Removing old loose-fill

Working in a cathedral or a low attic

Cellulose or fibreglass, and when it matters

What it does for sound

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Lynnwood Edmonton: your questions answered

How is old insulation removed?

With a vacuum and hose into sealed bags, not shovels, because disturbing decades of settled material raises a lot of dust. It also gives a clean deck to air-seal and a look at the structure before it is covered again.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Can you just add over what is already up there?

Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.

What do I get when the job is done?

The bag count, the target settled depth, and photographs of the finished space including the corners and the eaves — so you can confirm years later what was actually installed instead of probing a hole and guessing.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.