Loose Fill Insulation Lee Ridge

Loose-fill insulation in Lee Ridge, measured rather than estimated

Blown-in material fills the awkward parts of an Lee Ridge building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Ceiling penetrations air-sealed first, not buried
• Baffles at the eaves so soffit venting stays clear
• Depth read back at the corners, not just where the hatch is
• Even coverage carried right out over the top plates

Loose Fill Insulation Lee Ridge

The hatch, again, because it undoes the rest

Lee Ridge drywall in context

Moisture is what ruins it

Storage areas and the platform question

Removing old loose-fill

Cellulose or fibreglass, and when it matters

Bath fans and the ducts above the ceiling

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Lee Ridge: your questions answered

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

My bathroom fan vents into the attic. Does that matter?

A great deal — it is the fastest way to soak an attic from inside. We look for it while the space is open and flag it before covering anything rather than blowing over the top of it.

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.