Loose Fill Insulation King Edward Park

Loose-fill insulation in King Edward Park — settled depth is what you are buying

Blown-in material fills the awkward parts of an King Edward Park building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Ceiling penetrations air-sealed first, not buried
• Depth read back at the corners, not just where the hatch is
• Baffles at the eaves so soffit venting stays clear
• Even coverage carried right out over the top plates

Loose Fill Insulation King Edward Park

Bag count is the honest check

King Edward Park drywall in context

What it does for sound

Loose-fill or batts, decided on the space

Working in a cathedral or a low attic

Filling around bracing and trusses

The material must not block the eaves

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation King Edward Park: your questions answered

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.