Loose Fill Insulation Heritage Valley Town Centre Area

Blown-in insulation for Heritage Valley Town Centre Area attics and closed cavities

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Heritage Valley Town Centre Area attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

• Even coverage carried right out over the top plates
• Ceiling penetrations air-sealed first, not buried
• Baffles at the eaves so soffit venting stays clear
• Depth read back at the corners, not just where the hatch is
• Settled depth specified and marked before the hose starts
• Existing material assessed — topped up, or removed if it is wet or contaminated

Loose Fill Insulation Heritage Valley Town Centre Area

Filling around bracing and trusses

Heritage Valley Town Centre Area drywall in context

Topping up what is already there

Access, hoses and how much of the house we cross

Pot lights buried in loose material

Removing old loose-fill

Moisture is what ruins it

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Heritage Valley Town Centre Area: your questions answered

Is it too heavy for my ceiling?

Rarely, but worth thinking about on an older lath ceiling or a long unsupported span. Where the ceiling is old or already sagging we would rather use the lighter material at a sensible depth, and sometimes recommend fixing the ceiling first.

My bathroom fan vents into the attic. Does that matter?

A great deal — it is the fastest way to soak an attic from inside. We look for it while the space is open and flag it before covering anything rather than blowing over the top of it.

Will it make the house quieter?

It noticeably reduces airborne noise from outside — traffic, aircraft, neighbours. It does very little for footsteps from a floor above, which travel through structure, and we would rather say which half it fixes.

Cellulose or fibreglass?

Both work. Cellulose is denser, packs into odd shapes and resists air movement through it better; fibreglass is lighter, which matters on a ceiling of uncertain strength. Where there is existing material, matching it is usually simpler than layering the other over it.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

Do you seal before blowing?

Yes, and it is the step most often skipped. Loose material laid over an open ceiling penetration hides the leak rather than stopping it, and the warm moist air coming through is what wets the insulation from inside.