Loose Fill Insulation Grovenor Edmonton

Blown-in insulation for Grovenor attics and closed cavities

Blown-in material fills the awkward parts of an Grovenor building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Existing material assessed — topped up, or removed if it is wet or contaminated
• Baffles at the eaves so soffit venting stays clear
• Even coverage carried right out over the top plates
• Settled depth specified and marked before the hose starts
• Ceiling penetrations air-sealed first, not buried
• Depth read back at the corners, not just where the hatch is

Loose Fill Insulation Grovenor Edmonton

Moisture is what ruins it

Grovenor drywall in context

Storage areas and the platform question

Topping up what is already there

Bag count is the honest check

Cellulose or fibreglass, and when it matters

Loose-fill or batts, decided on the space

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Grovenor Edmonton: your questions answered

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Do you seal before blowing?

Yes, and it is the step most often skipped. Loose material laid over an open ceiling penetration hides the leak rather than stopping it, and the warm moist air coming through is what wets the insulation from inside.

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.