Loose Fill Insulation Eaux Claires

Loose-fill insulation in Eaux Claires — settled depth is what you are buying

Blown-in material fills the awkward parts of an Eaux Claires building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Depth read back at the corners, not just where the hatch is
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Even coverage carried right out over the top plates
• Baffles at the eaves so soffit venting stays clear
• Settled depth specified and marked before the hose starts
• Ceiling penetrations air-sealed first, not buried

Loose Fill Insulation Eaux Claires

Loose-fill or batts, decided on the space

Eaux Claires drywall in context

Pot lights buried in loose material

Cellulose or fibreglass, and when it matters

The material must not block the eaves

Blowing into a wall that is already closed

Topping up what is already there

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Eaux Claires: your questions answered

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

How is old insulation removed?

With a vacuum and hose into sealed bags, not shovels, because disturbing decades of settled material raises a lot of dust. It also gives a clean deck to air-seal and a look at the structure before it is covered again.

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.