Loose Fill Insulation Capilano

Loose-fill insulation in Capilano, measured rather than estimated

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Capilano attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

• Baffles at the eaves so soffit venting stays clear
• Settled depth specified and marked before the hose starts
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Ceiling penetrations air-sealed first, not buried
• Even coverage carried right out over the top plates
• Depth read back at the corners, not just where the hatch is

Loose Fill Insulation Capilano

Cellulose or fibreglass, and when it matters

Capilano drywall in context

Moisture is what ruins it

Topping up what is already there

The hatch, again, because it undoes the rest

Settled depth versus installed depth

Filling around bracing and trusses

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Capilano: your questions answered

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

Is it too heavy for my ceiling?

Rarely, but worth thinking about on an older lath ceiling or a long unsupported span. Where the ceiling is old or already sagging we would rather use the lighter material at a sensible depth, and sometimes recommend fixing the ceiling first.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.