Loose Fill Insulation Canon Ridge Edmonton

Blown-in insulation for Canon Ridge attics and closed cavities

Blown-in material fills the awkward parts of an Canon Ridge building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Settled depth specified and marked before the hose starts
• Ceiling penetrations air-sealed first, not buried
• Even coverage carried right out over the top plates
• Baffles at the eaves so soffit venting stays clear
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Depth read back at the corners, not just where the hatch is

Loose Fill Insulation Canon Ridge Edmonton

What we hand over at the end

Canon Ridge drywall in context

Settled depth versus installed depth

Moisture is what ruins it

Working in a cathedral or a low attic

Topping up what is already there

Knob-and-tube and older wiring

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Canon Ridge Edmonton: your questions answered

Will it make the house quieter?

It noticeably reduces airborne noise from outside — traffic, aircraft, neighbours. It does very little for footsteps from a floor above, which travel through structure, and we would rather say which half it fixes.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Cellulose or fibreglass?

Both work. Cellulose is denser, packs into odd shapes and resists air movement through it better; fibreglass is lighter, which matters on a ceiling of uncertain strength. Where there is existing material, matching it is usually simpler than layering the other over it.

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.