Loose Fill Insulation Callingwood South Edmonton

Blown-in insulation for Callingwood South attics and closed cavities

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Callingwood South attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

• Ceiling penetrations air-sealed first, not buried
• Settled depth specified and marked before the hose starts
• Even coverage carried right out over the top plates
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Baffles at the eaves so soffit venting stays clear
• Depth read back at the corners, not just where the hatch is

Loose Fill Insulation Callingwood South Edmonton

Bath fans and the ducts above the ceiling

Callingwood South drywall in context

The material must not block the eaves

Loose-fill or batts, decided on the space

What we hand over at the end

Access, hoses and how much of the house we cross

Pot lights buried in loose material

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Callingwood South Edmonton: your questions answered

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.

Can I still store things in the attic?

Only over a raised platform. Anything laid straight on the joists compresses the material and cuts a thin channel through the middle of the ceiling. Otherwise a fully insulated attic is not also a storage room.

Will it make the house quieter?

It noticeably reduces airborne noise from outside — traffic, aircraft, neighbours. It does very little for footsteps from a floor above, which travel through structure, and we would rather say which half it fixes.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

Will it block my soffit vents?

Not if baffles go in first. Loose material can also be pushed around by wind at the eaves, so the baffles both hold it clear of the vents and stop the edge being scoured thin — which is exactly where the house loses heat.

Do you seal before blowing?

Yes, and it is the step most often skipped. Loose material laid over an open ceiling penetration hides the leak rather than stopping it, and the warm moist air coming through is what wets the insulation from inside.