Loose Fill Insulation Bulyea Heights Edmonton

Loose-fill insulation in Bulyea Heights — settled depth is what you are buying

Blown-in material fills the awkward parts of an Bulyea Heights building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Existing material assessed — topped up, or removed if it is wet or contaminated
• Ceiling penetrations air-sealed first, not buried
• Depth read back at the corners, not just where the hatch is
• Settled depth specified and marked before the hose starts
• Even coverage carried right out over the top plates
• Baffles at the eaves so soffit venting stays clear

Loose Fill Insulation Bulyea Heights Edmonton

The hatch, again, because it undoes the rest

Bulyea Heights drywall in context

Knob-and-tube and older wiring

Bath fans and the ducts above the ceiling

Blowing into a wall that is already closed

Working in a cathedral or a low attic

Storage areas and the platform question

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Bulyea Heights Edmonton: your questions answered

How is old insulation removed?

With a vacuum and hose into sealed bags, not shovels, because disturbing decades of settled material raises a lot of dust. It also gives a clean deck to air-seal and a look at the structure before it is covered again.

What if you find old wiring?

If we find wiring that must not be covered, we stop and say so rather than blowing over it. That is an electrician's call, not ours, and it is a real reason a job gets paused rather than finished the same day.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

Do you seal before blowing?

Yes, and it is the step most often skipped. Loose material laid over an open ceiling penetration hides the leak rather than stopping it, and the warm moist air coming through is what wets the insulation from inside.

Is blown-in better than batts?

In an attic, usually yes, because it flows around trusses, bracing and wiring where batts get cut short or forced and leave gaps. In open framed walls at regular spacing, batts are fine. We recommend by the space, not by what is on the truck.

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.