Loose Fill Insulation Brookside Edmonton

Loose-fill insulation in Brookside — settled depth is what you are buying

Blown-in material fills the awkward parts of an Brookside building that batts leave gapped — around cross-bracing, over the top plates of interior walls, into the shallow triangle at the eaves. It settles over time, which is why it is specified at a settled depth rather than the depth it looks on the day. Air sealing comes first, because loose material laid over an open ceiling penetration hides the leak instead of stopping it.

• Even coverage carried right out over the top plates
• Depth read back at the corners, not just where the hatch is
• Settled depth specified and marked before the hose starts
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Baffles at the eaves so soffit venting stays clear
• Ceiling penetrations air-sealed first, not buried

Loose Fill Insulation Brookside Edmonton

Topping up what is already there

Brookside drywall in context

Settled depth versus installed depth

Bag count is the honest check

Blowing into a wall that is already closed

Pot lights buried in loose material

Loose-fill or batts, decided on the space

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Brookside Edmonton: your questions answered

Cellulose or fibreglass?

Both work. Cellulose is denser, packs into odd shapes and resists air movement through it better; fibreglass is lighter, which matters on a ceiling of uncertain strength. Where there is existing material, matching it is usually simpler than layering the other over it.

How is old insulation removed?

With a vacuum and hose into sealed bags, not shovels, because disturbing decades of settled material raises a lot of dust. It also gives a clean deck to air-seal and a look at the structure before it is covered again.

How messy is it?

Dusty — the machine sits outside and a hose runs through the house to the hatch. We protect the route, seal around the hatch and vacuum afterwards. What the house looks like at the end is most of the difference between crews.

How do I know I got what I paid for?

Bag count. Every bag states the area it covers at a given depth, so bags used divided by area is exactly what went in. We keep them, mark the target settled depth, and read the depth back at the corners rather than the middle.

Does loose-fill settle?

Yes, which is why it is specified at a settled depth rather than how it looks on the day. A job blown to look right can measure short a year later. We work to the published settled figure and mark it before starting.

Will it make the house quieter?

It noticeably reduces airborne noise from outside — traffic, aircraft, neighbours. It does very little for footsteps from a floor above, which travel through structure, and we would rather say which half it fixes.