Loose Fill Insulation Bellevue Edmonton

Loose-fill insulation in Bellevue — settled depth is what you are buying

Loose-fill insulation is blown in rather than cut and fitted, which makes it the right answer wherever a batt cannot go: over an irregular Bellevue attic floor, around trusses and bracing, and into wall cavities that are already closed. What you are paying for is settled depth spread evenly, and that is a thing which can be measured. Depth markers go in before the hose starts, and we read them at the corners rather than in the middle where it is always deepest.

• Settled depth specified and marked before the hose starts
• Ceiling penetrations air-sealed first, not buried
• Depth read back at the corners, not just where the hatch is
• Even coverage carried right out over the top plates
• Existing material assessed — topped up, or removed if it is wet or contaminated
• Baffles at the eaves so soffit venting stays clear

Loose Fill Insulation Bellevue Edmonton

Topping up what is already there

Bellevue drywall in context

What we hand over at the end

What it does for sound

Moisture is what ruins it

Bath fans and the ducts above the ceiling

Bag count is the honest check

Simple, clean, on schedule — Drywall in Edmonton

Loose Fill Insulation Bellevue Edmonton: your questions answered

How is old insulation removed?

With a vacuum and hose into sealed bags, not shovels, because disturbing decades of settled material raises a lot of dust. It also gives a clean deck to air-seal and a look at the structure before it is covered again.

Can you blow insulation into my walls without opening them?

Often yes — dense-pack through small holes, packed hard enough that it does not slump and leave a cold band at the top. The holes then need filling and finishing, which is drywall work, so we quote that with it rather than surprising you.

Can I still store things in the attic?

Only over a raised platform. Anything laid straight on the joists compresses the material and cuts a thin channel through the middle of the ceiling. Otherwise a fully insulated attic is not also a storage room.

Does the attic hatch need doing too?

Yes, or it undoes a good part of the rest. It needs an insulated weatherstripped cover and a dam around the opening tall enough to hold the new depth back from spilling through every time it is opened.

What about my pot lights?

Older recessed fixtures are not all rated to be covered and loose-fill packs right against them. We check the rating, and where they are not rated they get a proper clearance detail that is also sealed, rather than being buried and hoped about.

Can you just add over what is already up there?

Usually, and it is the best value if the existing material is dry, even and uncontaminated. If it is damp, matted, rodent-affected or hiding unsealed penetrations, adding over it buries the problem — we tell you which one we found.