Is attic insulation part of the same job?

Related but different — different products, different equipment, and it is about even depth to the eaves with baffles and a sealed ceiling below. We quote it separately rather than folding it into a wall price.

Do you install vapour barrier too in Starling?

Yes — where the Starling assembly calls for it, vapour barrier goes over the insulation, sealed, before drywall.

Is insulation enough on its own?

No. It slows heat conduction but does nothing to stop air moving through gaps, and in an Alberta winter that air carries heat and moisture. A full cavity behind an unsealed top plate performs far below its rating.

Do you insulate basement developments to code in Starling?

Yes — we install batt and vapour barrier to the R-value your Starling basement development requires. We also cover Breckenridge Greens, Edgemont, Glastonbury and West Henday.

Do you insulate basement developments to code in Starling?

Yes — the R-value your Breckenridge Greens, Edgemont, Glastonbury basement needs is what we install, batt plus vapour barrier. We also cover Breckenridge Greens, Edgemont, Glastonbury and West Henday.

Do you also do the drywall after insulation in Starling?

Yes — take the full Breckenridge Greens, Edgemont, Glastonbury package or just the insulation stage ahead of your own boarders.

Insulation Installation Starling Edmonton | Batt Insulation

Batt and acoustic insulation in Starling before the board

Insulation is the step that gets covered and forgotten in Starling — exactly why it must be right the first time: full cavity fill, no gaps or compression, vapour barrier where needed. In Starling we install batt and acoustic insulation in walls and ceilings ahead of drywall. Starling is this established West Henday community where reno, repair and ceiling drywall are common, so basement development and the occasional upgrade where older insulation has settled or thinned are common here. We cover Starling, Breckenridge Greens, Edgemont, Glastonbury and West Henday, 7 days a week.

No-gap, no-compression cavity fill in Starling
The insulation stage before Starling new-build and reno drywall
Acoustic insulation for sound-dampening walls
Batt insulation in walls and ceilings in Breckenridge Greens, Edgemont, Glastonbury
Pre-drywall insulation for Starling builds and renos
Insulating Starling walls before construction and reno board goes up
Breckenridge Greens, Edgemont, Glastonbury coverage — we come to you

Compression, and why wider is not better

The trapped air does the work

Squashing a batt into a narrow bay reduces the still air it holds, which is the entire mechanism.

Measure first

Starling framing is not always at standard spacing, especially in renovations and older homes. Batts get cut to the actual bay rather than forced, which is slower and is the difference between paying for a rating and getting one.

Insulation is only half the assembly

Air movement is the other half

Insulation slows heat conduction. It does nothing to stop air moving through a gap, and in an Starling winter that air carries both heat and moisture.

Why we look at both

A cavity full of good batts behind an unsealed top plate performs far below its rating. We would rather quote the sealing alongside the insulation than install one and let you believe you bought the other.

Attic insulation is a different job

Depth and coverage

An attic is about even depth right out to the eaves, with baffles keeping the soffit vents clear and the ceiling below sealed.

Why we separate it

It uses different products and different equipment from wall work. We quote it separately rather than folding it into a wall price, because the two are only related by the word insulation.

Our Starling insulation installation process in Edmonton, step by step

Full cavity fill, no shortcuts

We cut and fit batt insulation to fill each stud or joist cavity completely in your Breckenridge Greens, Edgemont, Glastonbury home — a gap or a compressed corner is where heat loss and sound leak through.

Vapour barrier and drywall-ready

Where the assembly calls for it, we install vapour barrier over the insulation, sealed at the edges, then leave the wall ready for drywall to go straight on. See our basement drywall work in Breckenridge Greens, Edgemont, Glastonbury for what comes next.

Basements, and why they are not like upper floors

Concrete changes everything

An Starling foundation wall is cold and can carry ground moisture. Insulation pressed straight against it sits where moisture cannot dry.

The right assembly

The framing is held off the concrete or a rigid layer goes on first, so the cavity insulation stays on the warm side. Getting the order wrong is the usual reason a finished basement smells musty in year two.

Rim joists and the coldest band in the house

Small area, big loss

The rim joist where the floor framing meets the foundation is thin, directly exposed and usually the worst-performing part of an Starling basement.

Sealed then insulated

The joint gets air-sealed first, then insulated. A batt tucked loosely against a bare rim joist can trap moist air against cold wood, which is worse than leaving it alone.

How it works

Simple, clean, on schedule — Insulation Installation in Starling Edmonton

Free quote

We come out to your Starling Edmonton property, take a real look at the insulation installation, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every insulation installation quote in Starling Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the insulation installation in Starling Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Starling Edmonton home while we finish the insulation installation to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished insulation installation with us and you're happy with the result in Starling Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the insulation installation contractor Starling Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your insulation installation project in Starling Edmonton.

Read our reviews on Google

FAQ — Insulation Installation Starling Edmonton

Insulation Installation Starling Edmonton: your questions answered

Is attic insulation part of the same job?: Related but different — different products, different equipment, and it is about even depth to the eaves with baffles and a sealed ceiling below. We quote it separately rather than folding it into a wall price.
Do you install vapour barrier too in Starling?: Yes — where the Starling assembly calls for it, vapour barrier goes over the insulation, sealed, before drywall.
Is insulation enough on its own?: No. It slows heat conduction but does nothing to stop air moving through gaps, and in an Alberta winter that air carries heat and moisture. A full cavity behind an unsealed top plate performs far below its rating.
Do you insulate basement developments to code in Starling?: Yes — we install batt and vapour barrier to the R-value your Starling basement development requires. We also cover Breckenridge Greens, Edgemont, Glastonbury and West Henday.
Do you insulate basement developments to code in Starling?: Yes — the R-value your Breckenridge Greens, Edgemont, Glastonbury basement needs is what we install, batt plus vapour barrier. We also cover Breckenridge Greens, Edgemont, Glastonbury and West Henday.
Do you also do the drywall after insulation in Starling?: Yes — take the full Breckenridge Greens, Edgemont, Glastonbury package or just the insulation stage ahead of your own boarders.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Insulation

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Insulation Installation Starling Edmonton

Batt and acoustic insulation in Starling before the board