Is a board-only Allard garage job an option if I finish it?

Yes — we can board your Allard garage (with the required fire-rated separation) and leave the finishing and paint to you, or finish it fully.

Will the joints crack in an unheated garage?

It moves more than a heated room, going from well below freezing to warm in an afternoon. We fasten and tape to allow that, and we tell you honestly to expect more joint movement over years than indoors.

Can you do the insulation and vapour barrier as well as the boarding?

Yes, and we would rather do both so the sequence is right. Boarding over an incomplete or damaged vapour barrier hides a problem that surfaces later as staining, and it costs far more to fix through a finished wall.

Should I use moisture-resistant board in my garage?

It is worth it low on the walls where a vehicle brings snow in all winter. It is usually not worth upgrading the whole garage. Impact-resistant board on the two walls that actually get hit is normally the better spend.

Do you do garage drywall in Allard?

Yes — garage drywall in Allard is part of our regular work, and we are usually booked within the week. We also cover Ambleside, Blackburne, Blackmud Creek and Southwest.

Does it need sealing as well as boarding?

Yes. The same separation keeps exhaust fumes and stored-chemical vapour out of the house. Leaks around the man door, ceiling junction and penetrations are cheap to seal while open and awkward afterwards.

Garage Drywall Allard Edmonton | Garage Board

Garage drywall in Allard, boarded and fire-rated to code

Finishing a Allard garage adds warmth, cleanliness and value — provided the house-side wall and ceiling carry code fire-rating. In Allard we hang, tape and finish garage walls and ceilings, with Allard house-side separations built in Type X fire-rated board. Allard is an Southwest community with a mix of older homes and newer builds, so garage finishing here is common. We cover Allard, Ambleside, Blackburne, Blackmud Creek and Southwest, 7 days a week.

Insulation and vapour control before boarding
Impact-resistant board where vehicles and tools are close
Finish level matched to a working space, not a living room
Fire separation between garage and living space
Type X board where the assembly calls for it
Inspection-ready fire separation
Finished complete or boarded-for-paint — both offered in Allard

Insulation and vapour control before the board

Get this wrong and the board pays

In a Allard garage that is heated even occasionally, warm moist air meets cold surfaces. Without correct insulation and vapour control that moisture condenses inside the assembly, and the first symptom is usually stained or soft board near the ceiling.

Sequencing

Insulation and vapour control are inspected and complete before boarding starts. Boarding over an unfinished or damaged vapour barrier hides a problem that will surface later as staining or mould, and it costs far more to fix through a finished wall.

The wall to the house is the important one

Not just another wall

The common wall and ceiling between an attached Allard garage and the living space is a separation, and it is specified rather than optional.

What that changes

Board type, fastening, and how every penetration through it is treated. The other three walls of the garage are finish work; this one is the reason the job is inspected.

The fire separation between garage and house

When it applies

Where a Allard garage is attached, or living space sits above it, a rated separation is normally required between the two. That usually means Type X board on the shared wall and on the ceiling under living space, taped as part of the assembly.

The common gap

The most frequent thing we find in existing garages is board installed and joints left open. The board is there, so it looks finished — but an untaped rated assembly is not complete. Often the honest fix is finishing the joints rather than replacing the ceiling.

Finish level for a garage

Being realistic

A garage is lit harshly, viewed at close range along the walls, and rarely worth a top-level finish.

What we recommend

A sound taped finish, primed, in a durable washable coating. Spending on a display-level finish in a room that will meet a bumper and a bike rack is not where we would put a client's money, and we say so.

Why a Allard garage is harder on drywall than a house

The temperature cycle

An unheated Allard garage can swing tens of degrees in a day and cross freezing repeatedly through the winter. Board, framing and joint compound all move at different rates through that cycle, and the joints are where the difference shows.

What we do about it

Joints are taped and coated in thin passes and given time between coats rather than rushed, and the assembly is detailed so movement is taken at the joint instead of cracking the face. It is the same principle as any interior job, applied to a much harder environment.

Finishing around the vehicle door and the man door

The details that get skipped

The header over a Allard overhead door, the reveal around the man door and the junction where the garage wall meets the house are the spots most often left rough, because they are awkward and out of eye line.

Why they matter

They are also where the rated separation is most often broken and where air leakage is worst. We detail them properly, both for the assembly and because those edges are what you actually see when the overhead door is open.

How it works

Simple, clean, on schedule — Garage Drywall in Allard Edmonton

Free quote

We come out to your Allard Edmonton property, take a real look at the garage drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every garage drywall quote in Allard Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the garage drywall in Allard Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Allard Edmonton home while we finish the garage drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished garage drywall with us and you're happy with the result in Allard Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the garage drywall contractor Allard Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your garage drywall project in Allard Edmonton.

Read our reviews on Google

FAQ — Garage Drywall Allard Edmonton

Garage Drywall Allard Edmonton: your questions answered

Is a board-only Allard garage job an option if I finish it?: Yes — we can board your Allard garage (with the required fire-rated separation) and leave the finishing and paint to you, or finish it fully.
Will the joints crack in an unheated garage?: It moves more than a heated room, going from well below freezing to warm in an afternoon. We fasten and tape to allow that, and we tell you honestly to expect more joint movement over years than indoors.
Can you do the insulation and vapour barrier as well as the boarding?: Yes, and we would rather do both so the sequence is right. Boarding over an incomplete or damaged vapour barrier hides a problem that surfaces later as staining, and it costs far more to fix through a finished wall.
Should I use moisture-resistant board in my garage?: It is worth it low on the walls where a vehicle brings snow in all winter. It is usually not worth upgrading the whole garage. Impact-resistant board on the two walls that actually get hit is normally the better spend.
Do you do garage drywall in Allard in Edmonton?: Yes — garage drywall in Allard is part of our regular work, and we are usually booked within the week. We also cover Ambleside, Blackburne, Blackmud Creek and Southwest.
Does it need sealing as well as boarding?: Yes. The same separation keeps exhaust fumes and stored-chemical vapour out of the house. Leaks around the man door, ceiling junction and penetrations are cheap to seal while open and awkward afterwards.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Garage Drywall Allard Edmonton

Garage drywall in Allard, boarded and fire-rated to code