Should basement framing touch the concrete?

No. That puts wood and insulation against a cold and sometimes damp surface with no way to dry. The wall is held off, or a rigid layer goes on the concrete first. It costs an inch of floor and saves a musty basement.

Steel studs or wood in a basement?

Often a mix — steel for long partition runs where straightness matters, wood where cabinets and heavy fixings are going. Steel will not warp or rot; wood takes fasteners anywhere. We will say which we would use where.

Can the same crew do the drywall after framing in Larkspur?

Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.

Do you build bulkheads around ducting in Larkspur?

Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.

Do you build bulkheads around ducting in Larkspur?

Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.

Do you frame basement developments in Larkspur?

Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Bisset, Crawford Plains, Daly Grove and Mill Woods and Meadows.

Framing Larkspur Edmonton | Stud Walls

Framing in Larkspur, set out for the board that follows

Interior partition walls framed square and plumb
Bulkheads and soffits for ductwork and lighting
Door rough openings framed to spec
Larkspur coverage — we come to you
Wood-frame basement development layouts in Bisset, Crawford Plains, Daly Grove
Frame-to-finish: one crew frames, boards, tapes and finishes
Wood-frame basement development layouts in Larkspur

Basement framing against foundation walls in Edmonton

Hold it off the concrete

Framing tight against an Larkspur foundation wall puts wood and insulation against a cold, sometimes damp surface with no way to dry.

How it is done

The wall is held off, or a rigid layer goes on the concrete first. It costs an inch or two of floor space and it is the difference between a basement that stays dry and one that smells musty in year two.

Larkspur drywall in context

About Larkspur

Larkspur was named after an ornamental wildflower plant that blooms in many colours.

What we see in Larkspur

In Larkspur the drywall work is popcorn and stipple ceiling removal, settling+truss-uplift cracks, nail pops, Poly-B repipe patching repipe patching. We confirm what your home actually needs on site, in writing, before anything starts.

Framing decides how good the drywall can be in Edmonton

The finish inherits the frame

A wall that is out of plumb or has a bowed stud cannot be made flat with compound. Every problem left in an Larkspur frame becomes a finishing problem and then a visible one.

Why one crew helps

When the people framing know they will also be boarding and finishing, the incentive to crown studs properly and set a straight line is immediate rather than someone else's issue.

Door and window openings

Square, plumb and the right size

An opening framed even slightly out means the door will not hang properly, and no amount of shimming fully fixes a twisted opening.

What we check

Diagonals measured rather than eyeballed, and the rough opening sized to the actual door being installed rather than a standard assumed. Getting the real door dimensions before framing saves a return visit.

Why Larkspur homeowners trust Emplastrum for framing in Edmonton

Framed by the people who finish it

As a drywall and finishing company first, we frame walls the way we want to board and tape them — square, plumb and consistent — because no amount of mud hides a crooked frame in Bisset, Crawford Plains, Daly Grove.

Fixed price, same-day reply

We cover Bisset, Crawford Plains, Daly Grove and Mill Woods and Meadows, 7 days a week. Free on-site quotes and fixed prices, and we stand behind the work.

Layout for the sheet, not just for the room

Where the joints will land

Framing at the right spacing and adding backing where a sheet edge will fall means the board has something to fasten to at every joint.

Butt joints

An unsupported butt joint in an Larkspur wall is the hardest thing in drywall to hide. Thinking about sheet layout at framing stage removes them, and it costs nothing but attention.

Load-bearing walls and where we stop

Not our decision to make

Removing or altering a wall that carries load is a structural question, and we do not take a homeowner's assurance that a wall is non-bearing.

What we need

Drawings or an engineer's assessment. If a wall in an Larkspur renovation turns out to be bearing, the job becomes beams and posts — a different scope, and one far better priced before demolition than discovered during it.

How it works

Simple, clean, on schedule — Framing in Larkspur Edmonton

Free quote

We come out to your Larkspur Edmonton property, take a real look at the framing, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every framing quote in Larkspur Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the framing in Larkspur Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Larkspur Edmonton home while we finish the framing to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished framing with us and you're happy with the result in Larkspur Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the framing contractor Larkspur Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your framing project in Larkspur Edmonton.

Read our reviews on Google

FAQ — Framing Larkspur Edmonton

Framing Larkspur Edmonton: your questions answered

Should basement framing touch the concrete in Edmonton?: No. That puts wood and insulation against a cold and sometimes damp surface with no way to dry. The wall is held off, or a rigid layer goes on the concrete first. It costs an inch of floor and saves a musty basement.
Steel studs or wood in a basement?: Often a mix — steel for long partition runs where straightness matters, wood where cabinets and heavy fixings are going. Steel will not warp or rot; wood takes fasteners anywhere. We will say which we would use where.
Can the same crew do the drywall after framing in Larkspur in Edmonton?: Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.
Do you build bulkheads around ducting in Larkspur?: Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.
Do you build bulkheads around ducting in Larkspur?: Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.
Do you frame basement developments in Larkspur?: Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Bisset, Crawford Plains, Daly Grove and Mill Woods and Meadows.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Framing

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Framing Larkspur Edmonton

Framing in Larkspur, set out for the board that follows