Should basement framing touch the concrete?

No. That puts wood and insulation against a cold and sometimes damp surface with no way to dry. The wall is held off, or a rigid layer goes on the concrete first. It costs an inch of floor and saves a musty basement.

Do you frame basement developments in Kilkenny?

Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Balwin, Bannerman, Belmont and Northeast.

Do you coordinate with my electrician and plumber?

Yes — we sequence the framing so your other trades can rough in cleanly before insulation and drywall.

Do you build bulkheads around ducting in Kilkenny?

Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.

Can you add backing for a TV mount and shelves?

Yes, and tell us before the wall closes. Adding backing while it is open takes minutes; finding it missing afterwards means opening the wall or relying on anchors that eventually pull out. We ask what is going on the walls first.

Steel studs or wood in a basement?

Often a mix — steel for long partition runs where straightness matters, wood where cabinets and heavy fixings are going. Steel will not warp or rot; wood takes fasteners anywhere. We will say which we would use where.

Framing Kilkenny Edmonton | Stud Walls

Framing in Kilkenny, set out for the board that follows

Door rough openings framed to spec
Balwin, Bannerman, Belmont coverage — we come to you
Frame-to-finish: one crew frames, boards, tapes and finishes
Interior partition walls framed square and plumb
Kilkenny coverage — we come to you
Bulkheads and soffits for ductwork and lighting
Stud spacing matched to the drywall going over it

Framing decides how good the drywall can be in Edmonton

The finish inherits the frame

A wall that is out of plumb or has a bowed stud cannot be made flat with compound. Every problem left in an Kilkenny frame becomes a finishing problem and then a visible one.

Why one crew helps

When the people framing know they will also be boarding and finishing, the incentive to crown studs properly and set a straight line is immediate rather than someone else's issue.

Kilkenny drywall in context

About Kilkenny

Kilkenny lies to the City's far north, snuggled up against farms and forest.

What we see in Kilkenny

In Kilkenny the drywall work is plaster and lath repair, popcorn and stipple ceiling removal, careful patching into original surfaces. We confirm what your home actually needs on site, in writing, before anything starts.

Why Kilkenny homeowners trust Emplastrum for framing in Edmonton

Framed by the people who finish it

As a drywall and finishing company first, we frame walls the way we want to board and tape them — square, plumb and consistent — because no amount of mud hides a crooked frame in Balwin, Bannerman, Belmont.

Fixed price, same-day reply

We cover Balwin, Bannerman, Belmont and Northeast, 7 days a week. Free on-site quotes and fixed prices, and we stand behind the work.

Backing for everything that gets fixed later

Decide before it closes

Grab bars, TV mounts, floating shelves, cabinets, handrails and towel rails all need something solid behind the board.

The cheap moment

Adding backing while the Kilkenny wall is open takes minutes. Finding it missing after the wall is finished means opening it or relying on hollow-wall anchors that eventually pull out. We ask what is going on the walls before we close them.

Common framing situations in Kilkenny in Edmonton

In Kilkenny, kilkenny sits in Edmonton's Northeast district. Kilkenny lies to the City's far north, snuggled up against farms and forest. Across roughly 2,075 homes here, the drywall work is plaster and lath repair, popcorn and stipple ceiling removal, careful patching into original surfaces. We cover Kilkenny and the surrounding Northeast district, 7 days a week. Free on-site quote, one fixed price, and work that holds up after.

Steel studs against wood in a Kilkenny basement

Different tools for different jobs

Steel is straight, will not warp, does not burn and does not rot, which suits a basement or a shop. Wood takes fasteners anywhere and is easier for backing and heavy fixings.

How we choose

Often a mix — steel for the long partition runs where straightness matters, wood where cabinets and heavy items are going. We will say which we would use where and why.

What affects the cost of framing in Kilkenny in Edmonton?

Wall length, layout and openings

Framing cost in Kilkenny tracks the total wall length, the complexity of the layout, and the number of openings and bulkheads. We price off a site walk-through and give a fixed number before we start.

Typical framing work in Kilkenny homes

Because Kilkenny is a Northeast community with a mix of older homes and newer builds, framing calls here range from clean basement layouts in the newer homes to alteration work in the older ones.

How it works

Simple, clean, on schedule — Framing in Kilkenny Edmonton

Free quote

We come out to your Kilkenny Edmonton property, take a real look at the framing, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every framing quote in Kilkenny Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the framing in Kilkenny Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Kilkenny Edmonton home while we finish the framing to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished framing with us and you're happy with the result in Kilkenny Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the framing contractor Kilkenny Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your framing project in Kilkenny Edmonton.

Read our reviews on Google

FAQ — Framing Kilkenny Edmonton

Framing Kilkenny Edmonton: your questions answered

Should basement framing touch the concrete in Edmonton?: No. That puts wood and insulation against a cold and sometimes damp surface with no way to dry. The wall is held off, or a rigid layer goes on the concrete first. It costs an inch of floor and saves a musty basement.
Do you frame basement developments in Kilkenny?: Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Balwin, Bannerman, Belmont and Northeast.
Do you coordinate with my electrician and plumber?: Yes — we sequence the framing so your other trades can rough in cleanly before insulation and drywall.
Do you build bulkheads around ducting in Kilkenny?: Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.
Can you add backing for a TV mount and shelves?: Yes, and tell us before the wall closes. Adding backing while it is open takes minutes; finding it missing afterwards means opening the wall or relying on anchors that eventually pull out. We ask what is going on the walls first.
Steel studs or wood in a basement?: Often a mix — steel for long partition runs where straightness matters, wood where cabinets and heavy fixings are going. Steel will not warp or rot; wood takes fasteners anywhere. We will say which we would use where.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Framing

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Framing Kilkenny Edmonton

Framing in Kilkenny, set out for the board that follows