Can the same crew do the drywall after framing in Bannerman?

Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.

Can you add backing for a TV mount and shelves?

Yes, and tell us before the wall closes. Adding backing while it is open takes minutes; finding it missing afterwards means opening the wall or relying on anchors that eventually pull out. We ask what is going on the walls first.

Steel studs or wood in a basement?

Often a mix — steel for long partition runs where straightness matters, wood where cabinets and heavy fixings are going. Steel will not warp or rot; wood takes fasteners anywhere. We will say which we would use where.

Can the same crew do the drywall after framing in Bannerman?

Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.

Why does framing matter for the drywall finish?

Because the finish inherits the frame. A bowed stud or a wall out of plumb cannot be made flat with compound. Every problem left in the framing becomes a finishing problem and then a visible one.

Do you frame basement developments in Bannerman?

Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Balwin, Belmont, Belvedere and Northeast.

Framing Bannerman Edmonton | Stud Walls

Framing in Balwin, Belmont, Belvedere, square and ready for drywall

Bulkheads and soffits for ductwork and lighting
Frame-to-finish: one crew frames, boards, tapes and finishes
Wood-frame basement development layouts in Balwin, Belmont, Belvedere
Bannerman coverage — we come to you
Door rough openings framed to spec
Interior partition walls framed square and plumb
Balwin, Belmont, Belvedere coverage — we come to you

Why Bannerman homeowners trust Emplastrum for framing in Edmonton

Framed by the people who finish it

As a drywall and finishing company first, we frame walls the way we want to board and tape them — square, plumb and consistent — because no amount of mud hides a crooked frame in Balwin, Belmont, Belvedere.

Fixed price, same-day reply

We cover Balwin, Belmont, Belvedere and Northeast, 7 days a week. Free on-site quotes and fixed prices, and we stand behind the work.

Bannerman drywall in context

About Bannerman

Bannerman, who settled in the Belmont area in 1883, this area is part of the Clareview district and was annexed to the City, along with much of northeast Edmonton, in the early 1960s.

What we see in Bannerman

In Bannerman the drywall work is plaster and lath repair, popcorn and stipple ceiling removal, careful patching into original surfaces. We confirm what your home actually needs on site, in writing, before anything starts.

Basement framing against foundation walls in Edmonton

Hold it off the concrete

Framing tight against an Bannerman foundation wall puts wood and insulation against a cold, sometimes damp surface with no way to dry.

How it is done

The wall is held off, or a rigid layer goes on the concrete first. It costs an inch or two of floor space and it is the difference between a basement that stays dry and one that smells musty in year two.

Bulkheads, and why they are never straight by accident

Boxing what has to stay

Bannerman basements are full of ducts, beams and plumbing that cannot move. Bulkheads box them, and each one adds corners.

Getting them right

A bulkhead framed slightly out of square is obvious once it is boarded, because the eye follows its long lines. They take longer than their size suggests and they are worth the extra care.

Framing decides how good the drywall can be in Edmonton

The finish inherits the frame

A wall that is out of plumb or has a bowed stud cannot be made flat with compound. Every problem left in an Bannerman frame becomes a finishing problem and then a visible one.

Why one crew helps

When the people framing know they will also be boarding and finishing, the incentive to crown studs properly and set a straight line is immediate rather than someone else's issue.

Crowning studs and checking for bow

Every stud has a curve

Lumber is rarely straight. Crowning means sighting each stud and setting them all with the bow facing the same way so the wall plane is consistent.

What happens without it

Studs set randomly give a wall that waves in and out, and in an Bannerman room with a window running along it, that shows through the finished paint no matter how good the taping.

Leaving room for mechanical and electrical

Framing comes first, services follow

An Bannerman frame that leaves nowhere for a duct or a drain forces the mechanical trades to notch and drill in ways that weaken it.

Coordination

We would rather walk the layout with the other trades before framing than have them cut through a stud we set. It is a short conversation that avoids a structural argument later.

How it works

Simple, clean, on schedule — Framing in Bannerman Edmonton

Free quote

We come out to your Bannerman Edmonton property, take a real look at the framing, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every framing quote in Bannerman Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the framing in Bannerman Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Bannerman Edmonton home while we finish the framing to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished framing with us and you're happy with the result in Bannerman Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the framing contractor Bannerman Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your framing project in Bannerman Edmonton.

Read our reviews on Google

FAQ — Framing Bannerman Edmonton

Framing Bannerman Edmonton: your questions answered

Can the same crew do the drywall after framing in Bannerman in Edmonton?: Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.
Can you add backing for a TV mount and shelves?: Yes, and tell us before the wall closes. Adding backing while it is open takes minutes; finding it missing afterwards means opening the wall or relying on anchors that eventually pull out. We ask what is going on the walls first.
Steel studs or wood in a basement?: Often a mix — steel for long partition runs where straightness matters, wood where cabinets and heavy fixings are going. Steel will not warp or rot; wood takes fasteners anywhere. We will say which we would use where.
Can the same crew do the drywall after framing in Bannerman in Edmonton?: Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.
Why does framing matter for the drywall finish in Edmonton?: Because the finish inherits the frame. A bowed stud or a wall out of plumb cannot be made flat with compound. Every problem left in the framing becomes a finishing problem and then a visible one.
Do you frame basement developments in Bannerman?: Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Balwin, Belmont, Belvedere and Northeast.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Framing

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Framing Bannerman Edmonton

Framing in Balwin, Belmont, Belvedere, square and ready for drywall