Can pot lights go in a rated ceiling?

Only with fixtures and firestopping suited to that assembly. A standard fixture cut into a rated Stewart Greens ceiling breaks the separation. We coordinate the locations with your electrician so the penetrations are handled before we tape.

Do you install fire-rated drywall in Stewart Greens?

Yes — fire-rated drywall in Stewart Greens is part of our regular work, and we are usually booked within the week. We also cover Breckenridge Greens, Edgemont, Glastonbury and West Henday.

Do you handle the firestopping as well as the board?

We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.

Will it pass inspection in Stewart Greens?

Yes — we install the correct Type X assembly and seal penetrations to spec so your Stewart Greens separation passes inspection.

How do I know which rated assembly my Stewart Greens project needs?

It comes from your drawings or from the building official at permit stage, not from us and not from the board supplier. We build to the assembly you have been given, and if what is specified does not match what is on site we will tell you before boarding.

What if someone cuts into it later?

That is the risk — a fan, a light or a duct added later can quietly undo the assembly. We photograph the rated work before covering it so there is a record of what is behind the finish for whoever works on the house next.

Fire-Rated Drywall Stewart Greens Edmonton | Type X Board

Fire-rated drywall in Stewart Greens, installed to code

In Stewart Greens the code decides: garage separations, basement suites and party walls must carry Type X board in a rated assembly to pass inspection and protect the home. In Stewart Greens we install fire-rated drywall to code and finish it clean. Stewart Greens is this established West Henday community where reno, repair and ceiling drywall are common, so fire-rated work here is common on garages and suites. We cover Stewart Greens, Breckenridge Greens, Edgemont, Glastonbury and West Henday, 7 days a week.

Rated assemblies installed and sealed correctly
Penetrations firestopped before the finish goes on
Furnace and mechanical room enclosures
Type X fire-rated board to code in Stewart Greens
Stewart Greens coverage — we come to you
Garage-to-house firewall separations
Party walls and legal-suite separations

Penetrations are where ratings are lost

Every hole is a path

Electrical boxes, plumbing, ducting and pot lights all pierce a rated wall or ceiling in Stewart Greens. Each one is a route for fire and smoke unless it is firestopped to suit the assembly.

Sequencing matters

Firestopping happens before the finish goes on. We coordinate with your other trades so penetrations are made and sealed before we tape, rather than cut into a finished rated ceiling afterwards and leave it open behind the paint.

Sealing at the top and bottom of a rated wall

The wall has to be continuous

A rated separation that stops at a suspended ceiling, or has a gap at the floor, is not a separation. Fire and smoke go over and under it.

Deck to deck

In an Stewart Greens build the rated wall runs to the structure above and is sealed at both ends. It is the detail most often missed in conversions where a wall was built to the ceiling and no further.

One-hour and two-hour assemblies

What the number means

A rating is how long a tested assembly resisted fire under laboratory conditions, not a guarantee about your Stewart Greens house. One hour is the common residential separation; two hour appears between units in some buildings.

Why it changes the build

A two-hour assembly is usually two layers of board with offset joints, which changes material, labour and thickness. It is specified on the drawings and it is not something to substitute down.

What makes drywall fire-rated in Stewart Greens

The board is only part of it

Type X board carries a glass-fibre reinforced core that holds together longer under heat. That is what earns the rating in a lab, but only inside a tested assembly: a stated board thickness, stud spacing, screw pattern and joint treatment.

Why that matters on your job

Putting Type X on a wall does not make the wall rated. In Stewart Greens we build the assembly the drawings specify, because an inspector is checking the system, not the sticker on the board.

Why Stewart Greens homeowners trust Emplastrum for fire-rated drywall

To code, and finished clean

A rated assembly has to be right for safety and inspection, and finished well for the room — in Stewart Greens we do both, installing to code and finishing flat.

Fixed price, same-day reply

We install fire-rated drywall across Stewart Greens and West Henday, 7 days a week. Fixed pricing on free Stewart Greens quotes, a clean site and a guarantee on the work. When an Stewart Greens job is not right, we make it right — on us.

Joints, screws and the details inspectors actually check

The parts nobody photographs

A rated assembly in Stewart Greens depends on screw spacing, joints landing on framing, and joints being taped and filled. Loose screw spacing, unsupported butt joints and untaped joints are the usual reasons a rated wall does not pass.

Two-layer assemblies

Where the assembly is two layers, the second layer joints are offset from the first so no joint runs straight through the wall. That offset is part of the rating, not a finishing preference.

How it works

Simple, clean, on schedule — Fire-Rated Drywall in Stewart Greens Edmonton

Free quote

We come out to your Stewart Greens Edmonton property, take a real look at the fire-rated drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every fire-rated drywall quote in Stewart Greens Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the fire-rated drywall in Stewart Greens Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Stewart Greens Edmonton home while we finish the fire-rated drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished fire-rated drywall with us and you're happy with the result in Stewart Greens Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the fire-rated drywall contractor Stewart Greens Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your fire-rated drywall project in Stewart Greens Edmonton.

Read our reviews on Google

FAQ — Fire-Rated Drywall Stewart Greens Edmonton

Fire-Rated Drywall Stewart Greens Edmonton: your questions answered

Can pot lights go in a rated ceiling?: Only with fixtures and firestopping suited to that assembly. A standard fixture cut into a rated Stewart Greens ceiling breaks the separation. We coordinate the locations with your electrician so the penetrations are handled before we tape.
Do you install fire-rated drywall in Stewart Greens?: Yes — fire-rated drywall in Stewart Greens is part of our regular work, and we are usually booked within the week. We also cover Breckenridge Greens, Edgemont, Glastonbury and West Henday.
Do you handle the firestopping as well as the board?: We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.
Will it pass inspection in Stewart Greens?: Yes — we install the correct Type X assembly and seal penetrations to spec so your Stewart Greens separation passes inspection.
How do I know which rated assembly my Stewart Greens project needs?: It comes from your drawings or from the building official at permit stage, not from us and not from the board supplier. We build to the assembly you have been given, and if what is specified does not match what is on site we will tell you before boarding.
What if someone cuts into it later?: That is the risk — a fan, a light or a duct added later can quietly undo the assembly. We photograph the rated work before covering it so there is a record of what is behind the finish for whoever works on the house next.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Fire-Rated Drywall Stewart Greens Edmonton

Fire-rated drywall in Stewart Greens, installed to code