Do you stand behind your fire-rated work in Sherwood Park?

Yes. We install to code and walk the Sherwood Park job with you, and if something is not right we come back and make it right.

Can I put an access hatch in my rated garage ceiling?

Only with a rated detail. Any hatch interrupts the assembly. It is a common find in Sherwood Park garages where storage access was cut in afterwards and never addressed.

Will it pass inspection in Sherwood Park?

Yes — we install the correct Type X assembly and seal penetrations to spec so your Sherwood Park separation passes inspection.

Is Type X the same as fireproof?

No. Type X resists fire for a stated period inside a tested assembly, which buys time to get out. Nothing about it makes a wall fireproof, and the rating only holds if the whole assembly — board, spacing, joints and penetrations — is built as specified.

Can I use 1/2 inch board if that is what is on site?

Not in a rated assembly. Type X is 5/8 inch because the core needs that mass and reinforcement to hold together under heat. It looks identical once finished and it is not the tested assembly — we check board against the specification.

Can you finish over rated board so it looks like the rest of the room?

Yes. The rated joint treatment comes first because it is part of the assembly, then the visible finish is taken to whatever level suits the room. A Sherwood Park garage ceiling and a living room do not need the same finish level.

Fire-Rated Drywall Sherwood Park | Type X Board

Rated separations in Sherwood Park that pass inspection the first time

Most fire-rated work we do in Sherwood Park is one of four things: a garage ceiling under living space, a party wall between units, a furnace or mechanical room, or a legal-suite separation. Each has its own assembly, and the drawings or the building official decide which one applies — not us and not the supplier.

Garage ceilings and garage-to-house separations in Sherwood Park
Penetrations firestopped before the finish goes on
Rated assemblies installed and sealed correctly
Furnace and mechanical room enclosures
Sherwood Park coverage — we come to you
Party walls and legal-suite separations
Type X board to the assembly on the drawings

What affects the cost of fire-rated drywall in Sherwood Park?

Area and assembly

The cost in Sherwood Park depends on the area and the rated assembly required — a single-layer garage ceiling is different from a two-layer party wall. The Sherwood Park rating drives the build-up, and Type X board carries a premium over standard. We price off the spec and a site look.

Passing inspection in Sherwood Park

The common rated jobs here are garages and suites. The rating only holds if the assembly is built and sealed exactly to spec, so we install it to code and seal penetrations properly so your Sherwood Park project passes the first time.

Sherwood Park drywall in context

About Sherwood Park

A high share of Sherwood Park homes date from the Poly-B era, so repipe patching and texture matching after a plumbing replacement is common here.

What we see in Sherwood Park

In Sherwood Park the drywall work is both plaster and stipple repair and new-build basement development. We confirm what your home actually needs on site, in writing, before anything starts.

Penetrations are where ratings are lost

Every hole is a path

Electrical boxes, plumbing, ducting and pot lights all pierce a rated wall or ceiling in Sherwood Park. Each one is a route for fire and smoke unless it is firestopped to suit the assembly.

Sequencing matters

Firestopping happens before the finish goes on. We coordinate with your other trades so penetrations are made and sealed before we tape, rather than cut into a finished rated ceiling afterwards and leave it open behind the paint.

One-hour and two-hour assemblies

What the number means

A rating is how long a tested assembly resisted fire under laboratory conditions, not a guarantee about your Sherwood Park house. One hour is the common residential separation; two hour appears between units in some buildings.

Why it changes the build

A two-hour assembly is usually two layers of board with offset joints, which changes material, labour and thickness. It is specified on the drawings and it is not something to substitute down.

Where Sherwood Park homes usually need rated board

The four common places

Most rated drywall in Sherwood Park houses is one of: the garage ceiling where living space sits above it, the garage-to-house wall, the furnace or mechanical room, and a legal-suite separation between dwelling units.

Renovations trigger it too

Finishing a basement, adding a suite or converting a garage often brings a separation into play that was not there before. If you are not sure whether your Sherwood Park project triggers one, that is a question for the building official at permit stage, and we will tell you when we think you should ask.

Coordinating with the electrician early

Boxes in rated walls

Outlet and switch boxes in a rated Sherwood Park assembly need treatment — spacing rules, pads or listed boxes — and back-to-back boxes are a particular problem.

Why early matters

Rearranging a box after board is up means opening a rated wall. Walking the wall with the electrician before boarding takes ten minutes and avoids that entirely.

Sealing at the top and bottom of a rated wall

The wall has to be continuous

A rated separation that stops at a suspended ceiling, or has a gap at the floor, is not a separation. Fire and smoke go over and under it.

Deck to deck

In an Sherwood Park build the rated wall runs to the structure above and is sealed at both ends. It is the detail most often missed in conversions where a wall was built to the ceiling and no further.

How it works

Simple, clean, on schedule — Fire-Rated Drywall in Sherwood Park

Free quote

We come out to your Sherwood Park property, take a real look at the fire-rated drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every fire-rated drywall quote in Sherwood Park starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the fire-rated drywall in Sherwood Park. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Sherwood Park home while we finish the fire-rated drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished fire-rated drywall with us and you're happy with the result in Sherwood Park. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Sherwood Park Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the fire-rated drywall contractor Sherwood Park trusts for repair, restoration and finishing — rated on Google by Sherwood Park homeowners.

Read the reviews, or leave your own after your fire-rated drywall project in Sherwood Park.

Read our reviews on Google

FAQ — Fire-Rated Drywall Sherwood Park

Fire-Rated Drywall Sherwood Park: your questions answered

Do you stand behind your fire-rated work in Sherwood Park?: Yes. We install to code and walk the Sherwood Park job with you, and if something is not right we come back and make it right.
Can I put an access hatch in my rated garage ceiling?: Only with a rated detail. Any hatch interrupts the assembly. It is a common find in Sherwood Park garages where storage access was cut in afterwards and never addressed.
Will it pass inspection in Sherwood Park?: Yes — we install the correct Type X assembly and seal penetrations to spec so your Sherwood Park separation passes inspection.
Is Type X the same as fireproof?: No. Type X resists fire for a stated period inside a tested assembly, which buys time to get out. Nothing about it makes a wall fireproof, and the rating only holds if the whole assembly — board, spacing, joints and penetrations — is built as specified.
Can I use 1/2 inch board if that is what is on site?: Not in a rated assembly. Type X is 5/8 inch because the core needs that mass and reinforcement to hold together under heat. It looks identical once finished and it is not the tested assembly — we check board against the specification.
Can you finish over rated board so it looks like the rest of the room?: Yes. The rated joint treatment comes first because it is part of the assembly, then the visible finish is taken to whatever level suits the room. A Sherwood Park garage ceiling and a living room do not need the same finish level.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Fire-Rated Drywall Sherwood Park

Rated separations in Sherwood Park that pass inspection the first time