Do you handle the firestopping as well as the board?

We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.

How do I know which rated assembly my Sakaw project needs?

It comes from your drawings or from the building official at permit stage, not from us and not from the board supplier. We build to the assembly you have been given, and if what is specified does not match what is on site we will tell you before boarding.

My Sakaw garage ceiling has board but the joints are open. Is that a problem?

Usually yes. Untaped joints are one of the most common reasons a garage separation is not complete, because the board looks installed. Often the fix is finishing the joints and sealing penetrations rather than replacing the ceiling.

Is Type X the same as fireproof?

No. Type X resists fire for a stated period inside a tested assembly, which buys time to get out. Nothing about it makes a wall fireproof, and the rating only holds if the whole assembly — board, spacing, joints and penetrations — is built as specified.

Can you finish over rated board so it looks like the rest of the room?

Yes. The rated joint treatment comes first because it is part of the assembly, then the visible finish is taken to whatever level suits the room. A Sakaw garage ceiling and a living room do not need the same finish level.

Will it pass inspection in Sakaw?

Yes — we install the correct Type X assembly and seal penetrations to spec so your Sakaw separation passes inspection.

Fire-Rated Drywall Sakaw Edmonton | Type X Board

Type X board in Sakaw for garages, suites and mechanical rooms

Where code requires it in Sakaw, fire-rated board is mandatory: garage-to-house separations, suites and party walls take Type X in a rated assembly — for inspection and for safety. In Sakaw we install fire-rated drywall to code and finish it clean. Sakaw is an Mill Woods and Meadows community with a mix of older homes and newer builds, so fire-rated work here is common on garages and suites. We cover Sakaw, Bisset, Crawford Plains, Daly Grove and Mill Woods and Meadows, 7 days a week.

Finished clean and inspection-ready
Sakaw coverage — we come to you
Basement legal-suite fire separations
Rated assemblies installed and sealed correctly
Furnace and mechanical room enclosures
Penetrations firestopped before the finish goes on
Type X fire-rated board to code in Sakaw

Coordinating with the electrician early

Boxes in rated walls

Outlet and switch boxes in a rated Sakaw assembly need treatment — spacing rules, pads or listed boxes — and back-to-back boxes are a particular problem.

Why early matters

Rearranging a box after board is up means opening a rated wall. Walking the wall with the electrician before boarding takes ten minutes and avoids that entirely.

Sakaw drywall in context

About Sakaw

One of the 27 Mill Woods neighbourhoods, Sakaw means "wooded area" in Cree.

What we see in Sakaw

In Sakaw the drywall work is popcorn and stipple ceiling removal, settling+truss-uplift cracks, nail pops, Poly-B repipe patching repipe patching. We confirm what your home actually needs on site, in writing, before anything starts.

Common fire-rated situations in Sakaw

In Sakaw, sakaw sits in Edmonton's Mill Woods and Meadows district. One of the 27 Mill Woods neighbourhoods, Sakaw means "wooded area" in Cree. Across roughly 1,380 homes here, the drywall work is popcorn and stipple ceiling removal, settling+truss-uplift cracks, nail pops, Poly-B repipe patching repipe patching. We cover Sakaw and the surrounding Mill Woods and Meadows district, 7 days a week. One fixed price after an honest on-site look, and the job done right the first time.

What happens when an assembly is altered later

Every future trade is a risk

A rated Sakaw wall or ceiling stays rated only while nobody cuts an unsealed hole in it. Later work — a fan, a light, a duct, a speaker — can quietly undo it.

What we leave you

We photograph the rated work before covering it, so there is a record of what is behind the finish for whoever works on the house next.

Where Sakaw homes usually need rated board

The four common places

Most rated drywall in Sakaw houses is one of: the garage ceiling where living space sits above it, the garage-to-house wall, the furnace or mechanical room, and a legal-suite separation between dwelling units.

Renovations trigger it too

Finishing a basement, adding a suite or converting a garage often brings a separation into play that was not there before. If you are not sure whether your Sakaw project triggers one, that is a question for the building official at permit stage, and we will tell you when we think you should ask.

Rated ceilings and the membrane above

Protecting the structure

A rated ceiling under living space is protecting the floor structure above it, which is why the board and its fastening are specified rather than optional.

Access hatches

Any hatch through it interrupts the assembly and needs a rated detail. It is a common find in Sakaw garages where storage access was cut in afterwards and never addressed.

Penetrations are where ratings are lost

Every hole is a path

Electrical boxes, plumbing, ducting and pot lights all pierce a rated wall or ceiling in Sakaw. Each one is a route for fire and smoke unless it is firestopped to suit the assembly.

Sequencing matters

Firestopping happens before the finish goes on. We coordinate with your other trades so penetrations are made and sealed before we tape, rather than cut into a finished rated ceiling afterwards and leave it open behind the paint.

How it works

Simple, clean, on schedule — Fire-Rated Drywall in Sakaw Edmonton

Free quote

We come out to your Sakaw Edmonton property, take a real look at the fire-rated drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every fire-rated drywall quote in Sakaw Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the fire-rated drywall in Sakaw Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Sakaw Edmonton home while we finish the fire-rated drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished fire-rated drywall with us and you're happy with the result in Sakaw Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the fire-rated drywall contractor Sakaw Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your fire-rated drywall project in Sakaw Edmonton.

Read our reviews on Google

FAQ — Fire-Rated Drywall Sakaw Edmonton

Fire-Rated Drywall Sakaw Edmonton: your questions answered

Do you handle the firestopping as well as the board?: We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.
How do I know which rated assembly my Sakaw project needs?: It comes from your drawings or from the building official at permit stage, not from us and not from the board supplier. We build to the assembly you have been given, and if what is specified does not match what is on site we will tell you before boarding.
My Sakaw garage ceiling has board but the joints are open. Is that a problem?: Usually yes. Untaped joints are one of the most common reasons a garage separation is not complete, because the board looks installed. Often the fix is finishing the joints and sealing penetrations rather than replacing the ceiling.
Is Type X the same as fireproof?: No. Type X resists fire for a stated period inside a tested assembly, which buys time to get out. Nothing about it makes a wall fireproof, and the rating only holds if the whole assembly — board, spacing, joints and penetrations — is built as specified.
Can you finish over rated board so it looks like the rest of the room?: Yes. The rated joint treatment comes first because it is part of the assembly, then the visible finish is taken to whatever level suits the room. A Sakaw garage ceiling and a living room do not need the same finish level.
Will it pass inspection in Sakaw?: Yes — we install the correct Type X assembly and seal penetrations to spec so your Sakaw separation passes inspection.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Fire-Rated Drywall Sakaw Edmonton

Type X board in Sakaw for garages, suites and mechanical rooms