Does the rated wall have to go above the ceiling?

Yes. A separation that stops at a suspended ceiling is not a separation — fire and smoke go over it. The wall runs to the structure above and is sealed at both ends. It is the detail most often missed in conversions.

Do you handle the firestopping as well as the board?

We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.

Can I use 1/2 inch board if that is what is on site?

Not in a rated assembly. Type X is 5/8 inch because the core needs that mass and reinforcement to hold together under heat. It looks identical once finished and it is not the tested assembly — we check board against the specification.

How do I know which rated assembly my Royal Gardens project needs?

It comes from your drawings or from the building official at permit stage, not from us and not from the board supplier. We build to the assembly you have been given, and if what is specified does not match what is on site we will tell you before boarding.

Will it pass inspection in Royal Gardens?

Yes — we install the correct Type X assembly and seal penetrations to spec so your Royal Gardens separation passes inspection.

Do you stand behind your fire-rated work in Royal Gardens?

Yes. We install to code and walk the Royal Gardens job with you, and if something is not right we come back and make it right.

Fire-Rated Drywall Royal Gardens Edmonton | Type X Board

Fire-rated drywall in Royal Gardens, installed to code

No shortcuts on Royal Gardens fire-rating — separations, suites and party walls need code Type X rated assemblies to clear inspection and keep people safe. In Royal Gardens we install fire-rated drywall to code and finish it clean. Royal Gardens is an established south Edmonton community of 1960s-70s homes where ceiling stipple, settling cracks and dated texture are common, so fire-rated work here is common on garages and suites. We cover Royal Gardens, Aspen Gardens, Bearspaw, Blue Quill and Whitemud, 7 days a week.

Party walls between units
Type X fire-rated board to code in Royal Gardens
Joints taped as part of the rated assembly, not just for looks
Penetrations firestopped before the finish goes on
Finished clean and inspection-ready
Type X board to the assembly on the drawings
Party walls and legal-suite separations

Fire-rated drywall in a Royal Gardens garage ceiling

The most common one we do

Where Royal Gardens living space sits over a garage, the ceiling normally needs a rated separation. It is also the assembly most often found incomplete on older homes and DIY conversions — board up, joints untaped, pot lights cut straight through.

What we check before quoting

We look at what is above the ceiling, what is already installed, and whether the existing board is actually rated. Sometimes the honest answer is that the existing ceiling only needs its joints completed and its penetrations sealed rather than replacing.

Royal Gardens drywall in context

About Royal Gardens

Royal Gardens is a mature suburban neighbourhood developed during the 1960s.

What we see in Royal Gardens

In Royal Gardens the drywall work is plaster and lath repair, popcorn and stipple ceiling removal, careful patching into original surfaces. We confirm what your home actually needs on site, in writing, before anything starts.

Joints, screws and the details inspectors actually check

The parts nobody photographs

A rated assembly in Royal Gardens depends on screw spacing, joints landing on framing, and joints being taped and filled. Loose screw spacing, unsupported butt joints and untaped joints are the usual reasons a rated wall does not pass.

Two-layer assemblies

Where the assembly is two layers, the second layer joints are offset from the first so no joint runs straight through the wall. That offset is part of the rating, not a finishing preference.

Inspection, and what we hand over

Sequencing with your inspection

Rated assemblies in Royal Gardens are usually inspected before the finish covers them, so we sequence boarding and firestopping to suit your inspection date rather than working ahead and covering something the inspector needs to see.

If something fails

If an assembly does not pass, we want to hear the inspector reason directly. Most failures are specific and fixable — a screw pattern, an untaped joint, an unsealed penetration — and are corrected faster from the actual note than from a second-hand summary.

Finishing a rated wall in Royal Gardens without compromising it

Rated first, pretty second

Taping on a rated assembly in Royal Gardens does two jobs: it completes the fire separation and it produces the surface you will paint. The tape and fill on the rated joints is not optional cosmetic work.

Level of finish

Beyond the rated joint treatment, the visible finish level is your choice — a garage ceiling rarely needs the same finish as a living room. We will tell you where a higher level is worth paying for and where it is not.

Why Royal Gardens homeowners trust Emplastrum for fire-rated drywall

To code, and finished clean

A rated assembly has to be right for safety and inspection, and finished well for the room — in Royal Gardens we do both, installing to code and finishing flat.

Fixed price, same-day reply

We install fire-rated drywall across Royal Gardens and Whitemud, 7 days a week. Fixed pricing on free Royal Gardens quotes, a clean site and a guarantee on the work. When an Royal Gardens job is not right, we make it right — on us.

Where Royal Gardens homes usually need rated board

The four common places

Most rated drywall in Royal Gardens houses is one of: the garage ceiling where living space sits above it, the garage-to-house wall, the furnace or mechanical room, and a legal-suite separation between dwelling units.

Renovations trigger it too

Finishing a basement, adding a suite or converting a garage often brings a separation into play that was not there before. If you are not sure whether your Royal Gardens project triggers one, that is a question for the building official at permit stage, and we will tell you when we think you should ask.

How it works

Simple, clean, on schedule — Fire-Rated Drywall in Royal Gardens Edmonton

Free quote

We come out to your Royal Gardens Edmonton property, take a real look at the fire-rated drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every fire-rated drywall quote in Royal Gardens Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the fire-rated drywall in Royal Gardens Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Royal Gardens Edmonton home while we finish the fire-rated drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished fire-rated drywall with us and you're happy with the result in Royal Gardens Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the fire-rated drywall contractor Royal Gardens Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your fire-rated drywall project in Royal Gardens Edmonton.

Read our reviews on Google

FAQ — Fire-Rated Drywall Royal Gardens Edmonton

Fire-Rated Drywall Royal Gardens Edmonton: your questions answered

Does the rated wall have to go above the ceiling?: Yes. A separation that stops at a suspended ceiling is not a separation — fire and smoke go over it. The wall runs to the structure above and is sealed at both ends. It is the detail most often missed in conversions.
Do you handle the firestopping as well as the board?: We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.
Can I use 1/2 inch board if that is what is on site?: Not in a rated assembly. Type X is 5/8 inch because the core needs that mass and reinforcement to hold together under heat. It looks identical once finished and it is not the tested assembly — we check board against the specification.
How do I know which rated assembly my Royal Gardens project needs?: It comes from your drawings or from the building official at permit stage, not from us and not from the board supplier. We build to the assembly you have been given, and if what is specified does not match what is on site we will tell you before boarding.
Will it pass inspection in Royal Gardens?: Yes — we install the correct Type X assembly and seal penetrations to spec so your Royal Gardens separation passes inspection.
Do you stand behind your fire-rated work in Royal Gardens?: Yes. We install to code and walk the Royal Gardens job with you, and if something is not right we come back and make it right.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Fire-Rated Drywall Royal Gardens Edmonton

Fire-rated drywall in Royal Gardens, installed to code