Do you stand behind your fire-rated work in MacEwan?

Yes. We install to code and walk the MacEwan job with you, and if something is not right we come back and make it right.

Do you handle the firestopping as well as the board?

We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.

Can you finish the fire-rated board too?

Yes — your MacEwan separation passes code and looks properly finished, ready for paint.

What if someone cuts into it later?

That is the risk — a fan, a light or a duct added later can quietly undo the assembly. We photograph the rated work before covering it so there is a record of what is behind the finish for whoever works on the house next.

Will it pass inspection in MacEwan?

Yes — we install the correct Type X assembly and seal penetrations to spec so your MacEwan separation passes inspection.

My MacEwan garage ceiling has board but the joints are open. Is that a problem?

Usually yes. Untaped joints are one of the most common reasons a garage separation is not complete, because the board looks installed. Often the fix is finishing the joints and sealing penetrations rather than replacing the ceiling.

Fire-Rated Drywall MacEwan Edmonton | Type X Board

Type X board in MacEwan for garages, suites and mechanical rooms

Most fire-rated work we do in MacEwan is one of four things: a garage ceiling under living space, a party wall between units, a furnace or mechanical room, or a legal-suite separation. Each has its own assembly, and the drawings or the building official decide which one applies — not us and not the supplier.

Furnace and mechanical room enclosures
Type X fire-rated board to code in MacEwan
Basement legal-suite fire separations
Party walls and legal-suite separations
Joints taped as part of the rated assembly, not just for looks
Type X board to the assembly on the drawings
Garage ceilings and garage-to-house separations in MacEwan

What affects the cost of fire-rated drywall in MacEwan?

Area and assembly

The cost in MacEwan depends on the area and the rated assembly required — a single-layer garage ceiling is different from a two-layer party wall. The MacEwan rating drives the build-up, and Type X board carries a premium over standard. We price off the spec and a site look.

Passing inspection in MacEwan

The common rated jobs here are garages and suites. The rating only holds if the assembly is built and sealed exactly to spec, so we install it to code and seal penetrations properly so your MacEwan project passes the first time.

MacEwan drywall in context

About MacEwan

MacEwan takes its name from John Walter Grant MacEwan (1902-2000) who was a local historian, author and politician.

What we see in MacEwan

In MacEwan the drywall work is first-year settling, basement dev for first owners, Level 5 over builder-grade. We confirm what your home actually needs on site, in writing, before anything starts.

Rated ceilings and the membrane above

Protecting the structure

A rated ceiling under living space is protecting the floor structure above it, which is why the board and its fastening are specified rather than optional.

Access hatches

Any hatch through it interrupts the assembly and needs a rated detail. It is a common find in MacEwan garages where storage access was cut in afterwards and never addressed.

Board thickness and why 5/8 is standard here

Not just thicker

Type X is 5/8 inch because the core needs that mass and the glass-fibre reinforcement to hold together as the gypsum calcines under heat.

The common error

Using 1/2 inch board in a rated MacEwan assembly because it is what was on site. It looks identical once finished and it is not the tested assembly. Board arriving on site is checked against the specification rather than assumed.

Why MacEwan homeowners trust Emplastrum for fire-rated drywall

To code, and finished clean

A rated assembly has to be right for safety and inspection, and finished well for the room — in MacEwan we do both, installing to code and finishing flat.

Fixed price, same-day reply

We install fire-rated drywall across MacEwan and Southwest, 7 days a week. Fixed pricing on free MacEwan quotes, a clean site and a guarantee on the work. When an MacEwan job is not right, we make it right — on us.

Coordinating with the electrician early

Boxes in rated walls

Outlet and switch boxes in a rated MacEwan assembly need treatment — spacing rules, pads or listed boxes — and back-to-back boxes are a particular problem.

Why early matters

Rearranging a box after board is up means opening a rated wall. Walking the wall with the electrician before boarding takes ten minutes and avoids that entirely.

One-hour and two-hour assemblies

What the number means

A rating is how long a tested assembly resisted fire under laboratory conditions, not a guarantee about your MacEwan house. One hour is the common residential separation; two hour appears between units in some buildings.

Why it changes the build

A two-hour assembly is usually two layers of board with offset joints, which changes material, labour and thickness. It is specified on the drawings and it is not something to substitute down.

How it works

Simple, clean, on schedule — Fire-Rated Drywall in Macewan Edmonton

Free quote

We come out to your Macewan Edmonton property, take a real look at the fire-rated drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every fire-rated drywall quote in Macewan Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the fire-rated drywall in Macewan Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Macewan Edmonton home while we finish the fire-rated drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished fire-rated drywall with us and you're happy with the result in Macewan Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the fire-rated drywall contractor Macewan Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your fire-rated drywall project in Macewan Edmonton.

Read our reviews on Google

FAQ — Fire-Rated Drywall MacEwan Edmonton

Fire-Rated Drywall MacEwan Edmonton: your questions answered

Do you stand behind your fire-rated work in MacEwan?: Yes. We install to code and walk the MacEwan job with you, and if something is not right we come back and make it right.
Do you handle the firestopping as well as the board?: We firestop the penetrations that fall within our scope and coordinate the sequence with the other trades so nothing is covered before it is sealed. Where a penetration belongs to another trade, we flag it rather than tape over it.
Can you finish the fire-rated board too?: Yes — your MacEwan separation passes code and looks properly finished, ready for paint.
What if someone cuts into it later?: That is the risk — a fan, a light or a duct added later can quietly undo the assembly. We photograph the rated work before covering it so there is a record of what is behind the finish for whoever works on the house next.
Will it pass inspection in MacEwan?: Yes — we install the correct Type X assembly and seal penetrations to spec so your MacEwan separation passes inspection.
My MacEwan garage ceiling has board but the joints are open. Is that a problem?: Usually yes. Untaped joints are one of the most common reasons a garage separation is not complete, because the board looks installed. Often the fix is finishing the joints and sealing penetrations rather than replacing the ceiling.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Fire-Rated Drywall MacEwan Edmonton

Type X board in MacEwan for garages, suites and mechanical rooms