Does the rated wall have to go above the ceiling?

Yes. A separation that stops at a suspended ceiling is not a separation — fire and smoke go over it. The wall runs to the structure above and is sealed at both ends. It is the detail most often missed in conversions.

Can pot lights go in a rated ceiling?

Only with fixtures and firestopping suited to that assembly. A standard fixture cut into a rated Lynnwood ceiling breaks the separation. We coordinate the locations with your electrician so the penetrations are handled before we tape.

Is Type X the same as fireproof?

No. Type X resists fire for a stated period inside a tested assembly, which buys time to get out. Nothing about it makes a wall fireproof, and the rating only holds if the whole assembly — board, spacing, joints and penetrations — is built as specified.

Do you install fire-rated drywall in Lynnwood?

Yes — fire-rated drywall in Lynnwood is part of our regular work, and we are usually booked within the week. We also cover Britannia Youngstown, Canora, Crestwood and Jasper Place.

Can I put an access hatch in my rated garage ceiling?

Only with a rated detail. Any hatch interrupts the assembly. It is a common find in Lynnwood garages where storage access was cut in afterwards and never addressed.

What if someone cuts into it later?

That is the risk — a fan, a light or a duct added later can quietly undo the assembly. We photograph the rated work before covering it so there is a record of what is behind the finish for whoever works on the house next.

Fire-Rated Drywall Lynnwood Edmonton | Type X Board

Fire-rated drywall in Lynnwood, built as a complete assembly

In Lynnwood the code decides: garage separations, basement suites and party walls must carry Type X board in a rated assembly to pass inspection and protect the home. In Lynnwood we install fire-rated drywall to code and finish it clean. Lynnwood is this established Jasper Place community where reno, repair and ceiling drywall are common, so fire-rated work here is common on garages and suites. We cover Lynnwood, Britannia Youngstown, Canora, Crestwood and Jasper Place, 7 days a week.

Garage-to-house firewall separations
Furnace and mechanical room enclosures
Basement legal-suite fire separations
Party walls between units
Penetrations firestopped before the finish goes on
Lynnwood coverage — we come to you
Type X board to the assembly on the drawings

Board thickness and why 5/8 is standard here

Not just thicker

Type X is 5/8 inch because the core needs that mass and the glass-fibre reinforcement to hold together as the gypsum calcines under heat.

The common error

Using 1/2 inch board in a rated Lynnwood assembly because it is what was on site. It looks identical once finished and it is not the tested assembly. Board arriving on site is checked against the specification rather than assumed.

Lynnwood drywall in context

About Lynnwood

A mature suburban neighbourhood, Lynnwood began its development as a part of the Town of Jasper Place during the 1950s.

What we see in Lynnwood

In Lynnwood the drywall work is plaster and lath repair, popcorn and stipple ceiling removal, careful patching into original surfaces. We confirm what your home actually needs on site, in writing, before anything starts.

Why Lynnwood homeowners trust Emplastrum for fire-rated drywall

To code, and finished clean

A rated assembly has to be right for safety and inspection, and finished well for the room — in Lynnwood we do both, installing to code and finishing flat.

Fixed price, same-day reply

We install fire-rated drywall across Lynnwood and Jasper Place, 7 days a week. Fixed pricing on free Lynnwood quotes, a clean site and a guarantee on the work. When an Lynnwood job is not right, we make it right — on us.

Where Lynnwood homes usually need rated board

The four common places

Most rated drywall in Lynnwood houses is one of: the garage ceiling where living space sits above it, the garage-to-house wall, the furnace or mechanical room, and a legal-suite separation between dwelling units.

Renovations trigger it too

Finishing a basement, adding a suite or converting a garage often brings a separation into play that was not there before. If you are not sure whether your Lynnwood project triggers one, that is a question for the building official at permit stage, and we will tell you when we think you should ask.

Our Lynnwood fire-rated drywall process, step by step

Right board, right build-up

In Lynnwood we confirm the required rating, then install the correct Type X board in the right layers — the assembly, not just the board, is what carries the rating.

Seal and finish

Penetrations and edges are where a rated assembly fails, so we firestop and seal them, then tape and finish the board clean. An Lynnwood separation the inspector approves and the eye approves too.

Type X and Type C are not interchangeable

Two different boards

Type X is the common 5/8 inch rated board. Type C carries additional additives that resist shrinkage at high heat and is specified where an assembly — often a ceiling — depends on the board staying in place longer.

Substituting downward fails

Where drawings call for Type C, Type X is not an equivalent, and an inspector who spots it will fail the assembly. We order to the specification on your Lynnwood drawings and tell you if what is on site does not match it.

Coordinating with the electrician early

Boxes in rated walls

Outlet and switch boxes in a rated Lynnwood assembly need treatment — spacing rules, pads or listed boxes — and back-to-back boxes are a particular problem.

Why early matters

Rearranging a box after board is up means opening a rated wall. Walking the wall with the electrician before boarding takes ten minutes and avoids that entirely.

How it works

Simple, clean, on schedule — Fire-Rated Drywall in Lynnwood Edmonton

Free quote

We come out to your Lynnwood Edmonton property, take a real look at the fire-rated drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every fire-rated drywall quote in Lynnwood Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the fire-rated drywall in Lynnwood Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Lynnwood Edmonton home while we finish the fire-rated drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished fire-rated drywall with us and you're happy with the result in Lynnwood Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the fire-rated drywall contractor Lynnwood Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your fire-rated drywall project in Lynnwood Edmonton.

Read our reviews on Google

FAQ — Fire-Rated Drywall Lynnwood Edmonton

Fire-Rated Drywall Lynnwood Edmonton: your questions answered

Does the rated wall have to go above the ceiling?: Yes. A separation that stops at a suspended ceiling is not a separation — fire and smoke go over it. The wall runs to the structure above and is sealed at both ends. It is the detail most often missed in conversions.
Can pot lights go in a rated ceiling?: Only with fixtures and firestopping suited to that assembly. A standard fixture cut into a rated Lynnwood ceiling breaks the separation. We coordinate the locations with your electrician so the penetrations are handled before we tape.
Is Type X the same as fireproof?: No. Type X resists fire for a stated period inside a tested assembly, which buys time to get out. Nothing about it makes a wall fireproof, and the rating only holds if the whole assembly — board, spacing, joints and penetrations — is built as specified.
Do you install fire-rated drywall in Lynnwood?: Yes — fire-rated drywall in Lynnwood is part of our regular work, and we are usually booked within the week. We also cover Britannia Youngstown, Canora, Crestwood and Jasper Place.
Can I put an access hatch in my rated garage ceiling?: Only with a rated detail. Any hatch interrupts the assembly. It is a common find in Lynnwood garages where storage access was cut in afterwards and never addressed.
What if someone cuts into it later?: That is the risk — a fan, a light or a duct added later can quietly undo the assembly. We photograph the rated work before covering it so there is a record of what is behind the finish for whoever works on the house next.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Fire-Rated Drywall Lynnwood Edmonton

Fire-rated drywall in Lynnwood, built as a complete assembly