Where is fire-rated drywall required?

The standard Kinglet Gardens fire-rating locations: garage-to-house walls, basement suites and party walls between units. We confirm what your Kinglet Gardens project needs.

Is Type X the same as fireproof?

No. Type X resists fire for a stated period inside a tested assembly, which buys time to get out. Nothing about it makes a wall fireproof, and the rating only holds if the whole assembly — board, spacing, joints and penetrations — is built as specified.

Will it pass inspection in Kinglet Gardens?

Yes — we install the correct Type X assembly and seal penetrations to spec so your Kinglet Gardens separation passes inspection.

Can I use 1/2 inch board if that is what is on site?

Not in a rated assembly. Type X is 5/8 inch because the core needs that mass and reinforcement to hold together under heat. It looks identical once finished and it is not the tested assembly — we check board against the specification.

Can you finish the fire-rated board too?

Yes — your Kinglet Gardens separation passes code and looks properly finished, ready for paint.

My Kinglet Gardens garage ceiling has board but the joints are open. Is that a problem?

Usually yes. Untaped joints are one of the most common reasons a garage separation is not complete, because the board looks installed. Often the fix is finishing the joints and sealing penetrations rather than replacing the ceiling.

Fire-Rated Drywall Kinglet Gardens Edmonton | Type X Board

Rated separations in Kinglet Gardens that pass inspection the first time

In Kinglet Gardens the code decides: garage separations, basement suites and party walls must carry Type X board in a rated assembly to pass inspection and protect the home. In Kinglet Gardens we install fire-rated drywall to code and finish it clean. Kinglet Gardens is this established West Henday community where reno, repair and ceiling drywall are common, so fire-rated work here is common on garages and suites. We cover Kinglet Gardens, Breckenridge Greens, Edgemont, Glastonbury and West Henday, 7 days a week.

Garage ceilings and garage-to-house separations in Kinglet Gardens
Furnace and mechanical room enclosures
Basement legal-suite fire separations
Party walls and legal-suite separations
Type X fire-rated board to code in Kinglet Gardens
Penetrations firestopped before the finish goes on
Garage-to-house firewall separations

Fire-rated garages, suites and party walls in Kinglet Gardens

Garage firewalls

The most common fire-rated job in Kinglet Gardens is the garage-to-house separation — Type X board on the common wall and ceiling. Code-compliant install and finish.

Legal suites and shared walls

Frequent work in Kinglet Gardens homes and multi-unit buildings. We build the rated separations these require. See our legal suite drywall page.

Joints, screws and the details inspectors actually check

The parts nobody photographs

A rated assembly in Kinglet Gardens depends on screw spacing, joints landing on framing, and joints being taped and filled. Loose screw spacing, unsupported butt joints and untaped joints are the usual reasons a rated wall does not pass.

Two-layer assemblies

Where the assembly is two layers, the second layer joints are offset from the first so no joint runs straight through the wall. That offset is part of the rating, not a finishing preference.

Why Kinglet Gardens homeowners trust Emplastrum for fire-rated drywall

To code, and finished clean

A rated assembly has to be right for safety and inspection, and finished well for the room — in Kinglet Gardens we do both, installing to code and finishing flat.

Fixed price, same-day reply

We install fire-rated drywall across Kinglet Gardens and West Henday, 7 days a week. Fixed pricing on free Kinglet Gardens quotes, a clean site and a guarantee on the work. When an Kinglet Gardens job is not right, we make it right — on us.

Sealing at the top and bottom of a rated wall

The wall has to be continuous

A rated separation that stops at a suspended ceiling, or has a gap at the floor, is not a separation. Fire and smoke go over and under it.

Deck to deck

In an Kinglet Gardens build the rated wall runs to the structure above and is sealed at both ends. It is the detail most often missed in conversions where a wall was built to the ceiling and no further.

Finishing a rated wall in Kinglet Gardens without compromising it

Rated first, pretty second

Taping on a rated assembly in Kinglet Gardens does two jobs: it completes the fire separation and it produces the surface you will paint. The tape and fill on the rated joints is not optional cosmetic work.

Level of finish

Beyond the rated joint treatment, the visible finish level is your choice — a garage ceiling rarely needs the same finish as a living room. We will tell you where a higher level is worth paying for and where it is not.

Our Kinglet Gardens fire-rated drywall process, step by step

Right board, right build-up

In Kinglet Gardens we confirm the required rating, then install the correct Type X board in the right layers — the assembly, not just the board, is what carries the rating.

Seal and finish

Penetrations and edges are where a rated assembly fails, so we firestop and seal them, then tape and finish the board clean. An Kinglet Gardens separation the inspector approves and the eye approves too.

How it works

Simple, clean, on schedule — Fire-Rated Drywall in Kinglet Gardens Edmonton

Free quote

We come out to your Kinglet Gardens Edmonton property, take a real look at the fire-rated drywall, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every fire-rated drywall quote in Kinglet Gardens Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the fire-rated drywall in Kinglet Gardens Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Kinglet Gardens Edmonton home while we finish the fire-rated drywall to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished fire-rated drywall with us and you're happy with the result in Kinglet Gardens Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the fire-rated drywall contractor Kinglet Gardens Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your fire-rated drywall project in Kinglet Gardens Edmonton.

Read our reviews on Google

FAQ — Fire-Rated Drywall Kinglet Gardens Edmonton

Fire-Rated Drywall Kinglet Gardens Edmonton: your questions answered

Where is fire-rated drywall required?: The standard Kinglet Gardens fire-rating locations: garage-to-house walls, basement suites and party walls between units. We confirm what your Kinglet Gardens project needs.
Is Type X the same as fireproof?: No. Type X resists fire for a stated period inside a tested assembly, which buys time to get out. Nothing about it makes a wall fireproof, and the rating only holds if the whole assembly — board, spacing, joints and penetrations — is built as specified.
Will it pass inspection in Kinglet Gardens?: Yes — we install the correct Type X assembly and seal penetrations to spec so your Kinglet Gardens separation passes inspection.
Can I use 1/2 inch board if that is what is on site?: Not in a rated assembly. Type X is 5/8 inch because the core needs that mass and reinforcement to hold together under heat. It looks identical once finished and it is not the tested assembly — we check board against the specification.
Can you finish the fire-rated board too?: Yes — your Kinglet Gardens separation passes code and looks properly finished, ready for paint.
My Kinglet Gardens garage ceiling has board but the joints are open. Is that a problem?: Usually yes. Untaped joints are one of the most common reasons a garage separation is not complete, because the board looks installed. Often the fix is finishing the joints and sealing penetrations rather than replacing the ceiling.

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Fire-Rated Drywall Kinglet Gardens Edmonton

Rated separations in Kinglet Gardens that pass inspection the first time