Do you remove ceiling drywall too in Tawa?

Yes — we tear out whole Tawa ceilings, textured and popcorn types included.

Can you take out this wall for me?

Only once we know it is not load-bearing, and that needs drawings or an engineer rather than an assumption. If it turns out to be bearing, the job becomes framing and beams, which is far better priced before demolition than discovered during it.

Is damage-free-framing removal possible in Tawa?

Yes — behind-the-board services and framing in Tawa come through our tear-outs intact for the next trade.

Can board come off Tawa walls with the studs left intact?

Yes — careful Tawa demolition leaves studs and hidden services untouched and ready to build on.

What happens to all the debris?

Drywall is heavy and cannot go in a household bin. Clean gypsum can often be recycled; board contaminated with insulation or suspect material cannot. We tell you which category your job is up front, because disposal is a real line in the price.

Do you also do the rebuild after demolition in Tawa?

Yes — one continuous Tawa job: tear-out, then framing, insulation and new drywall.

Drywall Removal & Demolition Tawa Edmonton | Tear-Out

Stripping walls and ceilings in Tawa back to framing

In Tawa, once a job goes past patching, tear-out comes first. In Tawa we remove old drywall from walls and ceilings, strip it back to the studs or framing, haul the debris off site, and leave the space ready for the next stage. Tawa is an Mill Woods and Meadows community with a mix of older homes and newer builds, so tear-out scopes here range from straightforward newer-home removal to older homes where plaster or extra layers need careful handling. We cover Tawa, Bisset, Crawford Plains, Daly Grove and Mill Woods and Meadows, 7 days a week.

Wall and ceiling drywall tear-out in Tawa
Careful removal around wiring, plumbing and ductwork
Prep for new framing, insulation or drywall
Dust containment and floor protection
Tawa coverage — we come to you
Full-room and whole-basement demolition
Debris hauled and disposed of

Asbestos and pre-1990 Tawa homes

Where it turns up

Drywall joint compound, texture coat and older ceiling stipple in Tawa homes built before roughly 1990 can contain asbestos. It is harmless undisturbed and hazardous once you sand or break it.

We stop rather than guess

If a house is of that era and the material is unknown, the honest answer is a test before demolition, not a judgement call on site. Testing is inexpensive relative to the cost of contaminating a house, and it is not something we will eyeball for you.

Tawa drywall in context

About Tawa

Tawa means "you are welcome" in the Cree language to honour Aboriginal leaders and history.

What we see in Tawa

In Tawa the drywall work is popcorn and stipple ceiling removal, settling+truss-uplift cracks, nail pops, Poly-B repipe patching repipe patching. We confirm what your home actually needs on site, in writing, before anything starts.

Screws, nails and what the framing looks like after

The stage nobody prices

After board comes off a Tawa wall, the framing is left studded with screws, nails and glue residue. New board over that will not sit flat.

Prep is part of removal

Fasteners come out, adhesive is scraped, and any framing damaged during removal is flagged. A demolition that stops at 'the board is off' hands the next trade a problem, and if we are also boarding it, that problem is ours.

What happens to the debris

Volume is the surprise

Drywall is dense. A single Tawa room generates more weight than most people picture, and it cannot go in a household bin.

Disposal and recycling

Clean gypsum can often be recycled where a facility accepts it; board contaminated with insulation, plastic or suspect material cannot. We tell you which category the job falls into up front, because disposal is a real line in the price rather than an afterthought.

Containment, and why it decides the whole job

Dust travels further than people expect

Drywall demolition in Tawa produces fine dust that moves through a house on air currents and settles in rooms nobody worked in.

What containment actually involves

Poly walls at the openings, floor protection on the route out, and negative pressure or a sealed room where the job justifies it. Furnace returns in the work area get covered, because a running furnace will distribute dust through the whole house in an afternoon.

Poly-B, plumbing repipes and access holes

Targeted openings, not demolition

A Tawa Poly-B repipe needs the plumber to reach the runs. That is a series of deliberate access holes, cut where the plumber needs them and where they are easiest to close.

Coordinating it

Cutting more than necessary makes the patching bill larger; cutting too little means the plumber cuts their own, usually in worse places. We would rather walk the route with the plumber first than react afterwards.

What has to happen before anything comes down

Power and water first

Before a wall opens in Tawa we identify what runs through it. Live circuits, water lines and gas all sit inside walls that look ordinary from the room side.

Why we ask about the age of the house

The service locations in a 1950s Tawa home are not where they are in a 2010 build, and the assumption that they are is how a demolition day turns into an emergency call. If drawings exist we want them; if they do not, we open cautiously and look.

How it works

Simple, clean, on schedule — Drywall Removal & Demolition in Tawa Edmonton

Free quote

We come out to your Tawa Edmonton property, take a real look at the drywall removal & demolition, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every drywall removal & demolition quote in Tawa Edmonton starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the drywall removal & demolition in Tawa Edmonton. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Tawa Edmonton home while we finish the drywall removal & demolition to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished drywall removal & demolition with us and you're happy with the result in Tawa Edmonton. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Edmonton Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the drywall removal & demolition contractor Tawa Edmonton trusts for repair, restoration and finishing — rated on Google by Edmonton homeowners.

Read the reviews, or leave your own after your drywall removal & demolition project in Tawa Edmonton.

Read our reviews on Google

FAQ — Drywall Removal & Demolition Tawa Edmonton

Drywall Removal & Demolition Tawa Edmonton: your questions answered

Do you remove ceiling drywall too in Tawa?: Yes — we tear out whole Tawa ceilings, textured and popcorn types included.
Can you take out this wall for me?: Only once we know it is not load-bearing, and that needs drawings or an engineer rather than an assumption. If it turns out to be bearing, the job becomes framing and beams, which is far better priced before demolition than discovered during it.
Is damage-free-framing removal possible in Tawa?: Yes — behind-the-board services and framing in Tawa come through our tear-outs intact for the next trade.
Can board come off Tawa walls with the studs left intact?: Yes — careful Tawa demolition leaves studs and hidden services untouched and ready to build on.
What happens to all the debris?: Drywall is heavy and cannot go in a household bin. Clean gypsum can often be recycled; board contaminated with insulation or suspect material cannot. We tell you which category your job is up front, because disposal is a real line in the price.
Do you also do the rebuild after demolition in Tawa?: Yes — one continuous Tawa job: tear-out, then framing, insulation and new drywall.

Need Edmonton’s go-to drywall contractor for repair, restoration and finishing? One trusted team for boarding, taping, finishing, repairs & renovations — start to finish.

Your Drywall Contractor in Edmonton →

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paintCavity depthFraming spacingInsulation already there (in)Top up to (in)Stud spacingDoorsWindowsWaste allowance (%)

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat; batt bundles by cavity depth, less a framing factor; studs at your chosen spacing plus waste). Product coverage varies by brand — confirm quantities before buying. Ask us about the right R-value for your project.

Rather we handle it? Get a free estimate →

Drywall Removal & Demolition Tawa Edmonton

Stripping walls and ceilings in Tawa back to framing