Batt Insulation Fraser Edmonton

Mineral wool and fibreglass batts in Fraser walls and ceilings

A batt only performs if it fills the cavity completely and is not squashed. In Fraser the two things that ruin it are compression — jamming a wider batt into a narrow bay — and gaps around wiring and boxes, where the insulation is stuffed behind rather than split around.

• Split and fitted around wiring and electrical boxes
• Batts friction-fit to full cavity width, not compressed
• Mineral wool where fire or sound performance matters
• Rim joists insulated and air-sealed
• Odd bays cut to fit rather than packed
• Vapour control detailed before the board goes on

Batt Insulation Fraser Edmonton

Faced, unfaced, and the vapour question

Fraser drywall in context

Friction fit, not stapled tight

Compression is the most common Fraser mistake

Handling, dust and leaving it clean

Rim joists, the coldest part of a Fraser basement

Cathedral ceilings and leaving the air gap

Simple, clean, on schedule — Batt Insulation in Fraser Edmonton

Batt Insulation Fraser Edmonton: your questions answered

Can you insulate my finished walls without removing the drywall?

Not with batts — they need an open cavity. That is a job for a blown-in or injected product, or for adding insulation on the room side. We will tell you that rather than sell you a partial job.

Do you insulate knee walls and attic hatches?

Yes, and they matter more than their size suggests. They are direct openings between heated and unheated space, and a well-insulated wall next to a bare knee wall performs like the weaker of the two.

My room is cold and draughty. Will batts fix it?

Probably not on their own. Draughts around windows, an unsealed rim joist or gaps at the top plate are air leaks, and insulation does not stop air. We would rather diagnose the draught and quote the sealing, which is usually the cheaper half.

Will insulating an interior wall help with noise?

Yes, noticeably for voices and television, even when sound was not the reason for the job. If a bedroom or office wall is open anyway, upgrading that cavity to a denser batt costs very little on top.

Do you cut batts to fit?

Yes. Real Fraser framing carries bays wider or narrower than nominal, plus cripples and blocking. Forced batts are compressed and underperform; short ones leave gaps that convect. Both are invisible after boarding.

There is a water pipe in my exterior wall. What happens to it?

Wherever the plumbing allows, the insulation goes behind the pipe so the pipe stays on the heated side. If it cannot, we flag it rather than boarding over a line we know is exposed to freezing.