Attic Insulation Rhatigan Ridge Edmonton

Attic insulation in Rhatigan Ridge: air seal first, then blow

Attics in Rhatigan Ridge lose depth over time — insulation settles, someone crawls through it for a wiring job, and the corners near the eaves are usually thin to begin with. A top-up is only worth doing if the baffles are clear and the ceiling below is sealed, so that is what we check before quoting.

• Attic hatch insulated and weatherstripped
• Depth markers left in place so the result is verifiable
• Baffles kept clear so the soffit vents still breathe
• Existing insulation levelled before the top-up
• Air sealing at pot lights, top plates and the attic hatch
• Blown-in loose-fill to the depth your permit specifies

Attic Insulation Rhatigan Ridge Edmonton

Adding to what is already there

Rhatigan Ridge drywall in context

The attic hatch nobody insulates

Cellulose against fibreglass in an Rhatigan Ridge attic

The eaves are where it goes thin

Topping up against removing and replacing

Storage in the attic

Simple, clean, on schedule — Attic Insulation in Rhatigan Ridge Edmonton

Attic Insulation Rhatigan Ridge Edmonton: your questions answered

Will insulating my attic stop the ice at my eaves?

Often it helps a great deal, because ice damming is usually escaping heat melting snow that then refreezes over the cold overhang. Air sealing plus even coverage to the eaves lowers the deck temperature, which is the actual cause.

Can you blow insulation over my pot lights?

Only if they are rated for contact with insulation. Older fixtures need clearance and have to be boxed or replaced. Either way they are significant air leaks, so they get sealed first.

How much insulation should my Rhatigan Ridge attic have?

The depth comes from what the code asks for on your permit, not from us. What we can tell you is the depth you have now, whether it is even, and whether the eaves and hatch are dealt with — those three often matter more than the last few inches.

Do I need to seal before adding insulation?

Yes, and it is the part most often skipped. Warm moist air leaking from the house frosts the roof deck and wets the insulation. Blowing over unsealed pot lights and top plates buries the problem instead of fixing it.

Why is the area above my exterior walls always cold?

Geometry. The roof meets the wall at the lowest point in the attic, so there is least room exactly where it is needed most. Baffles hold insulation back from the soffit vents while letting depth carry over the wall plate.

Should I block the vents to stop drafts?

No. The attic is meant to run close to outdoor temperature so the roof deck stays cold. Blocking soffit vents causes exactly the ice damming people add insulation to prevent.