Attic Insulation Dechene Edmonton

Blown-in attic insulation in Dechene, sealed before it is filled

The most common mistake in an Dechene attic is blowing insulation over an unsealed ceiling. Warm moist air keeps rising through pot lights, top plates and the hatch, and it carries moisture into cold insulation where it condenses. We air-seal the penetrations first, then insulate.

• Attic hatch insulated and weatherstripped
• Depth markers left in place so the result is verifiable
• Existing insulation levelled before the top-up
• Baffles kept clear so the soffit vents still breathe
• Blown-in loose-fill to the depth your permit specifies
• Air sealing at pot lights, top plates and the attic hatch

Attic Insulation Dechene Edmonton

What we can and cannot tell you about savings

Dechene drywall in context

The attic hatch nobody insulates

The eaves are where it goes thin

Keeping the eaves clear in an Dechene attic

Depth, and how to check we delivered it

The attic hatch, which everybody forgets

Simple, clean, on schedule — Attic Insulation in Dechene Edmonton

Attic Insulation Dechene Edmonton: your questions answered

Why does my Dechene attic frost up in winter?

Almost always warm moist air leaking up from the house through pot lights, top plates or the hatch, then condensing on cold sheathing. More insulation on its own does not fix it — the leaks have to be sealed first.

How much insulation should my attic have?

It is settled depth and even coverage that decide performance, not the product name. We set depth markers before blowing so the result is measurable, and check the corners rather than just the area near the hatch.

Should I block the vents to stop drafts?

No. The attic is meant to run close to outdoor temperature so the roof deck stays cold. Blocking soffit vents causes exactly the ice damming people add insulation to prevent.

Will insulating my attic stop the ice at my eaves?

Often it helps a great deal, because ice damming is usually escaping heat melting snow that then refreezes over the cold overhang. Air sealing plus even coverage to the eaves lowers the deck temperature, which is the actual cause.

How much will this save me on heating?

We will not put a percentage on it. Too much depends on your air leakage, windows and furnace. We will tell you what depth you have now, what you would have after, and where the leaks are — those we can actually measure.

Why is the area above my exterior walls always cold?

Geometry. The roof meets the wall at the lowest point in the attic, so there is least room exactly where it is needed most. Baffles hold insulation back from the soffit vents while letting depth carry over the wall plate.