Attic Insulation Avonmore Edmonton

Blown-in attic insulation in Avonmore, sealed before it is filled

The most common mistake in an Avonmore attic is blowing insulation over an unsealed ceiling. Warm moist air keeps rising through pot lights, top plates and the hatch, and it carries moisture into cold insulation where it condenses. We air-seal the penetrations first, then insulate.

• Existing insulation levelled before the top-up
• Air sealing at pot lights, top plates and the attic hatch
• Attic hatch insulated and weatherstripped
• Blown-in loose-fill to the depth your permit specifies
• Depth markers left in place so the result is verifiable
• Baffles kept clear so the soffit vents still breathe

Attic Insulation Avonmore Edmonton

Pot lights, and which ones can be covered

Avonmore drywall in context

The attic hatch nobody insulates

What we can and cannot tell you about savings

The attic hatch, which everybody forgets

Depth, and how to check we delivered it

Attics over additions and vaulted areas

Simple, clean, on schedule — Attic Insulation in Avonmore Edmonton

Attic Insulation Avonmore Edmonton: your questions answered

Can you blow insulation over my pot lights?

Only if they are rated for contact with insulation. Older fixtures need clearance and have to be boxed or replaced. Either way they are significant air leaks, so they get sealed first.

Do you insulate over an addition or a vaulted ceiling?

Those need looking at specifically rather than quoting an average depth. Shallow attics, cathedral sections and knee walls are usually the coldest rooms in an Avonmore house and the parts a general top-up misses.

My bathroom fan seems to vent into the attic. Is that a problem?

Yes, and it needs correcting before insulating. It dumps warm wet air into the coldest part of the house, and burying it under fresh insulation hides a moisture source that will show up later as frost and staining.

Cellulose or fibreglass?

Both work when installed to depth with the ceiling sealed underneath. Cellulose is denser and resists air movement better; fibreglass is lighter and settles less. We pick based on what is already up there and tell you why.

Why does my Avonmore attic frost up in winter?

Almost always warm moist air leaking up from the house through pot lights, top plates or the hatch, then condensing on cold sheathing. More insulation on its own does not fix it — the leaks have to be sealed first.

Why is the area above my exterior walls always cold?

Geometry. The roof meets the wall at the lowest point in the attic, so there is least room exactly where it is needed most. Baffles hold insulation back from the soffit vents while letting depth carry over the wall plate.